Astonica 50104264 User manual

230911rev1
Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
®
Made in China
©2011 World Factory, Inc.
Distributed by:
World Factory, Inc.
Westlake, TX 76262
Model No: 50104264
For warranty information, please refer to the back page of
this instruction manual.
Junior Tortoise Bench
Instruction Manual
Due to ongoing product development
the actual product or products may vary from
the illustrations or photos shown within this manual.
NOTE: This product is intended for residential, non-commercial use.
Limited Warranty
World Factory, Inc. Products for Home Use
World Factory, Inc. (Seller) warrants to the original Buyer only, that each Astonica Product will be free
from defects in material and workmanship for a period of one (1) year from date of purchase.
SELLER’S SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED
WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH
ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP. ANY PARTS AS DETERMINED BY THE
SELLER WHICH HAVE BEEN MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY
FROM REPAIRS OR ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER
MAINTENANCE, NEGLECT OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This
warranty does not apply to damage, heat-induced coloration changes, scratching or alteration due to
normal use or weathering. To make a claim under this Limited Warranty, you must return the complete
product with proof of purchase, transportation prepaid, to any World Factory, Inc. authorized service
center. Call 1-888-422-7800 for the location of the nearest authorized service center.
Additional Limitations
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED
TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1)
YEAR FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY INCIDENTAL
OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR LOSS OF
PROFITS, ARISING FROM THE SALE OR USE OF THIS PRODUCT.
If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such
provision shall not affect any other provision herein, this Limited Warranty shall be construed as if
such invalid and/or unenforceable provision had never been contained herein.
This warranty gives you special legal rights, and you may also have other rights which vary from state
to state.
This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all
prior agreements, arrangements, or understandings between the parties relating to product warranty.

A
F
H
I
Figure 1
C
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ASSEMBLY INSTRUCTIONS
CAUTION: Do not over tighten fasteners.
2. (SEE FIGURE 2) Attach the wood slats (B)
to left leg and arm frame (D) with bolts (G),
washers (H) and nuts (I). Repeat on the right
leg and arm frame, but do not tighten bolts
until all wood slats (B) are in place and bench
is upright on the floor.
3. Ensure all fasteners are securely tightened.
1. (SEE FIGURE 1) Using bolts (F), washers (H)
and nuts (I) attach one end of the straight
bench back (A) to the right leg & arm brace (C).
Attach the other end of the back to the
left leg & arm brace (D) using the same bolts,
washers and nuts.
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
B
C
I
G
J
EF
A
B
CD
Figure 2
12
NOTE: This product is intended for residential, non-commercial use.
GI
H
Figure 4 (I) Plastic Nut Cover
Four places backside
6. (SEE FIGURE 4) Add plastic nut covers (K)
to nuts (I) located on backside of straight
back (A).
4. (SEE FIGURE 3) Turn the bench over on a
non-scratch surface and attach middle
support bracket (E) to the slats (B) at the
midway point between legs and arm frames
using screws (J). Work from the front to back,
bending bracket (E) as necessary to fit the
contour of the slat seat.
Figure 3
D
H
A Straight Back 1
B Wood Seat Slats 4
C Right Leg & Arm Frame 1
D Left Leg & Arm Frame 1
E Middle Seat Brace 1
F 6mm x 32mm Bolt 4
G 6mm x 30mm Bolt 4
H 6mm Washer 6
I 6mm Nut 6
J Screw 4mm x 16mm 4
K Plastic Nut Cover 4
Parts Detail
J K
H
I
D
B
E
5. Ensure all fasteners are securely tightened.