Atdec AWM-W6 User manual

AWM-W6 Page 1 of 2
Installation Guide
AWM-W6
Wall Channel
COMPONENT CHECKLIST REQUIRED TOOLS
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation instructions.
! This product is compatible with Atdec modular (AWM) products.
! The manufacturer accepts no responsibility for incorrect installation.
A
Wall channel
(x1)
E
Nylon
Anchor (x2)
C
Top Cap
Screws
(x2)
B
Top Cap
(x1)
D
M6 x 50mm
Countersunk
Screw (x2)
• Power Drill
• 5.5mm (1/4”) Drill Bit
• 8mm (5/
16”) Drill Bit
• Phillips Head Screwdriver

AWM-W6 Page 2 of 2
2.3 Fit Top Cap
Phillips Head
Screwdriver
Top Cap
1. Install Wall Channel - Ensure all fasterners are installed
2. Mount Arm Assembly
2.1 Insert Arm Assembly into Channel
8mm (5/
16”) holes
5.5mm (1/
4”) holes
Nylon anchors
M6 x 50mm
Screws
M6 x 50mm
Screws
Note: Ensure
Clamp Head
Lever is vertical
and unlocked.
Note: Squeeze and hold
clamp jaws before inserting
into the Wall Channel.
2.2 Lock in position on the
wall channel by pushing the
lever down.
‘Click’
1.1 Masonry 1.2 Timber stud
atdec.com | atdec.co.uk | atdec.com.au
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©20170220C