ATI Technologies Scorpion X2 User manual

Scorpion X2 Pad
Part # A.5.10.1015
-Installation Instructions-
Thank you for purchasing an ATI product!
Buttpad Installation
Point the shotgun in a safe direction and place the safety in the "on" position. Next pull back the
slide, and carefully inspect the chamber to be sure the shotgun is unloaded.
www. ATIgunstocks.com Page 1
Step #1
Cut out the buttpad template below.
Note: If your ATI buttstock already has pre-drilled
holes for buttpad installation, skip to step #7.
Step #2
Pull down the latch lever and slide the ATI buttstock away
from the buffer tube.
Figure 1
Step #3
Place the buttpad template onto the buttstock and
secure the template to the buttstock with tape.
NOTE: Make sure the paper template is aligned
perfectly with the outside profile of the
buttstock. If the template is not aligned correctly,
the buttpad will not correctly assemble to the
stock.
Figure 2
Figure 3

Scorpion X2 Pad
Part # A.5.10.1015
-Installation Instructions-
Thank you for purchasing an ATI product!
Buttpad Installation
Step #4
With the template secured to the buttstock, use a
1/4" drill bit to drill 2 straight holes on each side of
the buttstock. Use the designated "X" in circles on
the template as markers for these 2 holes.
NOTE: ATI is NOT responsible for broken drill bits
Figure 4
Step #5
Using the circle on the template and the same 1/4"
drill bit, drill the single hole on the bottom of the
buttstock 1/8" deep.
NOTE: This hole will not be drilled through, you
must only drill 1/8" into the buttstock. The best
way to drill 1/8" is to measure 1/8" from the edge
of the drill bit and then place tape at the 1/8"
mark so you don't drill any deeper.
1/8"
Figure 5A
Figure 5B
Step #6
Remove the buttpad template and clean the
buttstock of any burrs and drilling material.
Figure 6
Step #7
Place the buttpad on the rear of the buttstock and
using a T-20 torx driver, install the (2) 8 x 48-2 x 1/2"
plastite torx head screws until snug.
Page 2
Figure 7