Atmel AT88RF020 User manual

AT88RF020 RF SMART CARD IC
2-KBIT READ/WRITE RF TRANSPONDER EEPROM
Key Features
• 2048-bit EEPROM Memory
• Contactless 13.56 MHz, ISO/IEC 14443 Type B Interface
• Password Protected User Memory
• Data Page Locking
• One-way Transaction Counter
• Integrated Tuning Capacitor
• High Reliability Memory, 100K Write Cycles with 10-year Data Retention
Applications
• Transit Tickets and Tokens
• Access Control Cards
• Product Traceability
• Document Authentication
The AT88RF020 is a low-cost, Type B contactless
EEPROM memory for use in cards, tags and tickets.
READ/WRITE RF SMART CARD IC SECURE RF

Atmel’s AT88RF020 low-cost 2-Kbit RF Transponder EEPROM Smart Card IC is fully
compliant with the Type B requirements of ISO/IEC 14443. This chip is powered by the
RF interface, so a battery is not needed. A tuning capacitor is included on-chip so only
a single external coil antenna is required to operate the device. The AT88RF020 is
compatible with any Type B RF Smart Card Reader.
Security
AT88RF020 has several security features. A 64-bit password protects the 224-byte user memory
which cannot be read or written unless the correct password has been presented. Write Lock bits
protect critical data from being over-written. Each Lock bit protects an 8-byte page, so once the
Lock bit is set the data can never be changed. The AT88RF020 features a one-way transaction
counter that allows tracking of individual device usage. The counter is set at the factory to zero
and is incremented by a COUNT command that simultaneously writes the Signature field. The
counter can never be reset or decremented. Atmel uniquely serializes each device with a 32-bit
read-only serial number.
Memory Map
AT88RF020 contains 256 bytes of memory configured as shown below. The first three pages can
always be read by the system. Page 3 is the password and can never be read. Pages 4 thru 31
are the user memory area that can only be accessed after password validation.
Product Features
• Contactless 13.56 Mhz RF Communications
Interface
– ISO/IEC 14443-2:2001 Type B Compliant
– ISO/IEC 14443-3:2001 Type B Compliant
Anticollision Protocol
– Command Set Optimized for Multicard RF
Communications
– Tolerant of Type A Signaling for
Multiprotocol Applications
– Operating Distance of 10 cm or more
• Integrated Tuning Capacitor
• 256 Byte EEPROM Memory
• 8-Byte Page Write Mode
• 224-Bytes User Memory
• 5 mS Write Time
• Security Features
– Unique Read-only PUPI Serial Number
– 64-bit Password
– One-way Transaction Counter
– Write Lock Data Protection
• High Reliability
– Endurance: 100,000 Write Cycles
– Data Retention: 10 Years
– Operating Temperature: 0°C to 70°C
Package Options
© Atmel Corporation 2003. All rights reserved.
Atmel® and combinations thereof are registered
trademarks of Atmel Corporation or its subsidiaries.
Other terms and product names may be the
trademarks of others.
REV: 2038B-08/03/7K
BYTE 0BYTE 1BYTE 2BYTE 3BYTE 4BYTE 5BYTE 6BYTE 7
Page 0 [ Unique Tag ID ] [ Lock Bits ]
Page 1 [ Application Data ] [ Reserved ]
Page 2 [ Signature ] [ Counter ]
Page 3 [ Password ]
Page 4 — — — — — — — —
…
…
Page 31 ————————
READ/WRITE RF SMART CARD ICSECURE RF
Atmel Corporation
2325 Orchard Parkway
San Jose, CA 95131
TEL [phone]
FAX [phone]
Regional Headquarters
Europe
Atmel Sarl
Route des Arsenaux 41
Case Postale 80
CH-1705 Fribourg
Switzerland
TEL [phone]
FAX [phone]
Asia
Room 1219
Chinachem Golden Plaza
77 Mody Road Tsimshatsui
East Kowloon
Hong Kong
TEL [phone]
FAX [phone]
Japan
9F, Tonetsu Shinkawa Bldg.
1-24-8 Shinkawa
Chuo-ku, Tokyo 104-0033
Japan
TEL [phone]
FAX [phone]
Product Contact
1150 East Cheyenne Mtn. Blvd.
Colorado Springs, CO 80906
USA
TEL [phone]
FAX [phone]
Literature Requests
www.atmel.com/literature
Web Site
www.atmel.com
Wafer Form, Thinned to 6 Mils RF Smart Card Modules Prelaminate Sheets
Development Tools
AT88RF020-DK Development Kit, including RF reader and software
Atmel Contact: [email protected]