Atmor Blue Wave User manual

Blue Wave Assembly Instructions Steps
1
Step 1
Step 2
Find The Place - Eye Level
and Sign 3 screws place

Blue Wave Assembly Instructions Steps
2
Step 3
Drilling 3 holes
and inserting 3 plugs
Step 4
Inserting 2 top screws

Blue Wave Assembly Instructions Steps
3
Step 5
Hang the unit on the 2 top
screws
Step 6
Insert the third bottom screw,
keeping the unit streight.

Blue Wave Assembly Instructions Steps
4
Step 7
Connect the Reinforced hose to
the water supply (don't forget to
insert the rubbers).
Step 8
Connect the second end of the
reinforced hose to the inlet water
connector of the unit. (on the left
side).

Blue Wave Assembly Instructions Steps
5
3 Way inlet hose posibility:
1. Top
2. Back
3. Bottom

Blue Wave Assembly Instructions Steps
6
Step 9
Connect the outlet hose to the
outlet connector. (in the middle
bottom of the unit)
Step 10
1. Insert the Soap dishes.
2. Insert the hand shower
holder.
3. Place the ends of the sliding
bar.
4. Place the sliding bar on
the wall on right height.
(Comfortable height for all
the users in the house)
5. Sign the 4 holes.

Blue Wave Assembly Instructions Steps
7
Step 11
1. Drilling 4 holes - 2 on top and
2 on the bottom.
2. Insert plugs
Step 12
Connect the sliding bar to the
wall using 4 screws

Blue Wave Assembly Instructions Steps
8
Step 13
Connect the cover of the Sliding
bar ends.
Step 14
Connect the hand shower to the
outlet hose end. (Don't forget
the ruber)
Hand it on the sliding bar.

Blue Wave Assembly Instructions Steps
9
Step 15
Open the water supply and
check for leakage.
Step 16
Insert the Electric cable threw
the back of the unit.

Blue Wave Assembly Instructions Steps
10
Step 17
Hold the cable with the cable
holder.
Step 18
Connect the electric cable to the
Terminal block.
LMN

Blue Wave Assembly Instructions Steps
11
Step 19
Open the Hose entry in the base
corner.
Step 20
Connect the corner to the the
base of the unit.

Blue Wave Assembly Instructions Steps
12
Step 21
Round the Knobs according to
the Facet and Rotering switch
Pivot.
Than put the cover of the unit
Step 22
Close the cover by 2 screws
One on the top and the second
on the bottom.

Blue Wave Assembly Instructions Steps
13
Step 23
Final view