Atmor INLINE 900 User manual

Hot Water on Demand
Step 4
Connect the Cold water hose to
the inlet on the left side of the unit.
(Don't forget to insert rubbers).
Be sure to use reinforced hose.
Be sure to close it properly.
Step 1
Find the optimal place.
Drill 4 holes and insert Plugs.
Step 2
Open the entrance cable in the
back of the unit.
Be sure to open the side of the
cable
Step 3
Hang the unit on the wall by 4
screws.
Don't forget to inset the electric
cable before.
Step 5
Connect the Hot water hose to the
outlet (Don’t forget the rubbers).
Be sure to use reinforced hose.
Be sure to close it well.
Open the water supply and check for
leakage around the hoses.
If there is no leakage - Go to step 6
leakage
Check again.
Don’t continue unless you sure
there is no leakage.
Step 6
Connect the electric cable to the
Terminal block.
Step 7
Close the cover by 4 short
screws
After closing the screws
Insert the Gray Bottom cover
NL
OUTLET
INLET
Atmor Super 900 - Assembly Steps
FREEPHONE 0800 101 201 / [e-mail] / www.atmor.co.nz
External PRD installed
at water inlet

Hot Water on Demand
Step 1
Fit isolating tap on
cold water supply
Step 2
Having already entered the
power cable, connect to the
terminal block.
Step 7
NL
Blue Wave 402 - Assembly Steps
FREEPHONE 0800 101 201 / [e-mail] / www.atmor.co.nz
Position heater at
eye level or higher.
Fix to the wall 2 top
and 1 bottom screw
Step 6
Step 4
Assemble and fit the sliding
shower bar to the wall including
the shower hose and rose
Step 3
Turn on the water to fill
the heating chamber and
check for leaks
Connect cold water supply
inlet hose
Step 5
Attach the front cover, round
the knobs to match the correct
pivot and secure by screw
top and bottom.
For further information on installation and operation
please refer to leaflet enclosed with the heater.