Avanti 16856 User manual

USER GUIDE
SLIM DIGITAL KITCHEN SCALE 5KGS/1G
Working mode
weight/water/milk
LCD display
On/O and zero button
LCD display screen
Unit measure button
Weighing area
FEATURES
Tare weight Time mode AM/PM
Volume unit (ml)
Weight unit (kg)
Volume unit (/oz)
Weight unit (lb/oz)
Negative value
Zero weight

USER GUIDE
1.
2.
SET UP
INSTALL OR REPLACE BATTERIES
Avanti®recommends high quality batteries for the best
product performance. Heavy duty and rechargeable
batteries are not recommended.
Remove the battery compartment cover by pushing
on the lever in the direction indicated by arrow.
Insert 2 x AAA batteries following the polarity (+/-)
symbols in the battery compartment.
3. Re-install battery compartment cover.
WARNING
This item requires batteries to operate. Batteries can cause a choking hazard.
ALWAYS KEEP OUT OF REACH OF CHILDREN.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY
SAFE WAY AND IN ACCORDANCE WITH LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY
Clean the battery contacts and those of the device prior to battery installation.
Remove batteries from equipment if not being used for an extended period. Follow the
polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries
from the device. Dispose of used batteries properly. Only batteries of the same or
equivalent type as recommended are to be used. DO NOT incinerate used batteries.
DO NOT dispose of batteries in re, as batteries may explode or leak. DO NOT mix old
and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable
batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the
supply terminals.

USER GUIDE
NOTE
button.
- To change units of measure between metric and imperial - hold down the UNIT
WEIGHT MODE
OPERATION
Always use the scale on a at, stable and clean surface.
WEIGHT UNIT MEASUREMENT
The scale oers both metric (grams) and imperial setting (lb:oz) options. Default unit
measurement setting is metric.
Press UNIT button to choose working mode – weight, water volume & milk volume.
Keep pressing to toggle between the dierent modes.
1. Place a bowl on the centre of the scale (if necessary) before turning on.
2. Press ZERO button to turn on scale.
3. Weighing can commence when the LCD display shows ‘0’.
4. Place item on to be measured and the weight will be shown on the display.
Weight mode Water volume mode Milk volume mode
Place on item
to be weighed

USER GUIDE
VOLUME MODE
If the item being measured is water or milk, press the UNIT button to choose volume
mode and view the volume of what is being weighed.
NOTE:
- When metric (g) is the weight unit, the default
volume unit is ‘ml’.
- When the imperial (lb:oz) is the weight unit, the
default volume is ‘’oz’.
1. Press ZERO button to turn on scale.
2. When the LCD display shows ‘0’, press UNIT
button to choose ‘Water’ or ‘Milk’ mode.
3. Place a container on the scale platform.
4. Press ZERO button to reset LCD display to ‘0’.
5. Pour liquid (milk or water) into the contained
volume will be shown on the display.
6. To view weight of liquid, press MODE button and
choose ‘weight’ mode.
Place on a
Pour in liquid

USER GUIDE
ZERO AND TARE FUNCTIONS
To weigh dierent items consecutively without removing each item from the scale, use
the Zero and Tare Functions.
NOTE:
1. Place a bowl on the scale platform.
2. Press the ZERO button to switch on the scale.
3. Weighing can commence when the LCD Display shows ‘0’.
4. Place the rst load within the bowl to take a reading and the LCD Display will show
the weight of the load.
5. Without removing the load, press the ZERO button to reset the display to ‘0’.
6. With the rst load still in place, add the next load. The display will now show the
weight of the newly added load.
AUTO SHUT OFF
Auto shut o occurs if display shows ‘0’ or the same weight reading for 2 minutes.
MANUAL SHUT OFF
To maximise the life of the battery, always press button to turn o the scale after use.
- If the total weight of loads being measured is below 4% of the scale’s capacity (less
than 200g) the Zero Function is in use and the Zero indicator will be displayed in
the bottom left corner of the LCD display.
- If the total weight of the loads exceeds 4% of the scales capacity (more than 200g)
the Tare Function is in use and the Tare indicator will be displayed on the top
left corner of the LCD display.
- When Tare Function mode is activated – when pressing the ZERO button between
loads, the LCD display will show the total weight of all loads on the scale. Press
ZERO button again to reset the LCD reading to ‘0’ and continue with the next load.

USER GUIDE
WARNING INDICATORS
CLEANING AND CARE
1. When LCD Display shows ‘Lo’, this indicates that battery needs
replacing.
2. When LCD Display shoes ‘Err’ this indicates maximum capacity
has been exceeded. Remove item to avoid damage to the scale.
(Max weight capacity is 5kg/11 lb).
TROUBLESHOOTING
PROBLEM POSSIBLE SOLUTION
Display screen is not working. Check that the battery is installed correctly.
Battery may need to be replaced.
SPECIFICATIONS
Model 16856
Maximum weight capacity 5kgs / 11lbs
Division 1g / 0.1oz
Product size 21.7 x 18.7 x 1.7cm
LCD display size
•Clean with a damp cloth only. A soft tissue with alcohol or glass cleaner can be
used to clean the stainless steel weighing platform.
•DO NOT immerse the scale in water or use chemical/abrasive cleaning agents.
•All plastic parts should be cleaned immediately after contact with fats, spices,
vinegar and strongly avoured / coloured foods.
•Avoid contact with acids such as citrus juices.
•Always use scales on a hard, at surface.
•DO NOT strike, shake or drop scale.
•Treat this precise instrument with care.
•Store in a cool and dry place.
3 x 6.5cm
Power 2 x 3V AAA batteries (included)
NOTE:
THIS SCALE IS FOR DOMESITC USE ONLY. DO NOT use for commercial purposes.
Avanti® is a registered trademark of Sheldon and Hammond Pty. Ltd.
A.B.N. 90 076 567 989.
Product made in China to rigid specication utilising high-grade materials. Packaging designed in Australia, ©Copyright Sheldon and Hammond Pty. Ltd. 2018.
Product Code 16856
www.avantihomewares.com
Table of contents
Other Avanti Scale manuals
Popular Scale manuals by other brands

Black & Decker
Black & Decker Scale manual

Axis
Axis 4B/NA Series instruction manual

TPS
TPS FEJ SERI instruction manual

Escali
Escali SmartConnect SC115KS product manual

Vitek
Vitek VT-2407 Manual instruction

Nicol Scales & Measurement
Nicol Scales & Measurement Sartorius Combics CAPXS Series operating instructions