Avigilon Access Control Manager Enterprise User manual

This package includes:
1. Access Control Manager Enterprise Appliance
2. Power Cord
2 Connect Crossover Cable
Connect a crossover cable from an available RJ-45
port on your configuring PC to Port 2 RJ-45 port
on the appliance. (This cable automatically sets
the computer’s IP address to the required fixed
address during the duration of this connection.)
3 Open Web Browser
Open the web browser on the connected PC and
type this IP address: 169.254.1.250.
If you get a message indicating a connection or
security error, refer to Troubleshooting on the
other side of this sheet for instructions.
Consult your IT manager for the IP Address and
Network Gateway values appropriate to your
installation.
6 Connect Appliance
to Network
Remove the crossover cable and move the
appliance to its required position in the system.
1. Using a standard Ethernet cable, connect
one end of the RJ-45 to an available RJ-45 port
on the appliance.
2. Connect the other
end of the Ethernet cable
to the network.
1 Plug In the Appliance
With the included power cord, plug the power plug
into the back of the appliance and the electric plug
into a wall outlet or surge protector.
avigilon.com
4 Login to the Application
When the log in screen appears, enter the login
name and password as “admin” then click Log in.
The Access Control Manager application main
menu appears.
5 Configure Port Settings
From the Access Control Manager application main
menu, perform these tasks:
1. From the top right corner, click Appliance.
2. Click the Ports tab.
3. From the Ethernet Configure page,
enter the required values. These include:
Name, IP Address, and Network Gateway.
4. Click the Save icon.
Connect to Port 2
Crossover Cable
(sold separately
through third-party
retailers)
Connect Power Cord
Access Control Manager Enterprise
Getting Started Guide
All logos and trademarks are the property of their respective owners. 920-0090A
QUICK START GUIDE

All logos and trademarks are the property of their respective owners. 920-0090A
QUICK START GUIDE
Troubleshooting
Access Control Manager Enterprise
4. Click the “Confirm Security Exception” button
Click “Continue to this website (not recommended).”
Click the “Continue” button
Click the “Proceed anyway” button
When using Safari:
2 If a security exception
screen appears...
1. Click the “Or you can add an exception...” link
2. Click the “Add Exception...” button
3. Click the “Get Certificate” button
1 If the Access Control
Manager application site is
not found and one of these
messages appears
When using Chrome:
A. If the Link LED on your router is not lit, make
sure the Ethernet cable is connected properly.
B. If a browser error message appears (like one
of the messages shown above), check to ensure
the network IP address is not set to 169.254.1.250
because that is the default IP address for the
Access Control Manager Appliance port.
C. To ensure the cable is properly connected and
there is no conflict with the IP address, type
“ping 169.254.1.250“ at a DOS command prompt.
If there is no response, please double check the
connection and IP address. If the connection
and IP address are correct, please call Avigilon
Technical Support for assistance.
When using Firefox:
When using Internet Explorer:
When using Firefox:
When using Chrome:
When using Safari:
When using Internet Explorer: