Axent AXENT.ONE C PLUS E314 User manual

AXENT.ONE C PLUS
INSTALLATION INSTRUCTIONS
E314

AXENT . ONE C PLUS
1
SAFETY SYMBOLS
The following warning signs warn you of dangerous situations and their severity:
DANGER! High Risk, Lethal Hazards, Severe Injuries
WARNING! Medium Risk, Severe Injuries
CAUTION! Low Risk, Minor Injuries
NOTE! Damage to Property
TARGET READERSHIP AND INSTALLER QUALIFICATIONS
Installation must be carried out by qualified professionals.
Repairs should only be performed by trained and qualified persons.
NOTE!
Follow all local installation regulations and country specific voltage and plumbing standards. DO NOT install the intelligent toilet in rooms where there is a
danger of frost. The room temperature and water temperature must not be less than 4°C ( 39 °F ).
Condensation may form when the intelligent toilet is brought from a cold location to a warm one. Leave the unit switched o for a few hours before operat-
ing.
DANGER!
Risk of fatal electric shock
The appliance must be grounded and plugged into a GFCI outlet.
DO NOT remove individual components from (inside of) the intelligent toilet.
If the unit has a damaged cord or plug, return the product to a service center for repair. The cord or plug may only be changed by qualified personnel.
CAUTION!
DO NOT reuse old hoses. Please use new hoses and included components.
Axent Corp is not liable or responsible for damaged caused by 3rd party components
TECHNICAL SUPPORT
For any questions or any assistance with this product, please contact your dealer or call us at
1-800-769-4857
[e-mail]
www.axentbath.us

SCOPE OF DELIVERY
2
Standard delivery contents
Remote Control
Main body 12" Base Flange Adhesive
USER MANUAL
AXENT.ONE C PLUS
User
Manual
Bowl
Mounting
Hardware
Holder
and Rubber
plug
AXENT.ONE C PLUS
INSTALLATION INSTRUCTIONS
Bowl Plug Remote Control
Mounting Hardware
Installation
Manual
Inlet Hose
and Filter
(Filter Adapter Requires
1/2" FIP Connection.)
Battery Anti-theft
Screws
The below parts are not included with the toilet.
Wax Ring Bolts Floor Mount

AXENT.ONE C PLUS
3
1
5 6
4
2
1
3
4
” -
8
”
9
“ - 14“
12
”
11 - 24
““
12
“
- 24
“
From installed surface, if any
(ex: baseboards, tiles, etc.)
12
/
5~15sec
1/2” Nominal Pipe Thread (NPT)
(Some 7/16” & 1/2” Slip-joint valve stops
utilize 1/2” NPT. Verify mating connection
with the included filter adapter first before
installation)
Please verify these dimensions before beginning installation.
These dimensions may vary in some locations.
Recommended operating pressure 40 - 80 psi.
Please run water until clear.

4
INSTALLATION
10 9
8 7
1
2
GFCI outlet

5
INSTALLATION
9 8
7 6
5 4
3
ø 0.24″
1.26″
2

6
INSTALLATION
4
3
2
1
13 OPTIONAL
12
11
10
≥55 min

7
TEST
SENSOR POSITION
There is a safety sensor
embedded within the seat
underneath this sticker.
Please make contact with
this area of the seat during
use for full functionality.
Please remove this sticker before the first use.
Please check for leaks before caulking.
2
4 3
1
3