AXIOMTEK AX93274 User manual

4 94193274010E
©Copyright 2014 Axiomtek Co., Ltd.
Version A1 July 2014
Printed in Taiwan
AX93274 Quick Installation Guide
94193274010E 1
©Copyright 2014 Axiomtek Co., Ltd.
Version A1 July 2014
Printed in Taiwan
Checklist
I/O board x1 LAN cable x1
Power cable x1 Thermal module x1
Note: Please contact your local vendors if any damaged or missing items. DO
NOT apply power to the board if there is any damaged component.
Connectors
Connector Description
CN1 Ethernet Connector
CN2 12V DC Power Out Connector
CN3 5V DC Power Out Connector
LAN1 RJ-45 Ethernet Port
Board Layout
Top View
Side View
AX93274 PoE-PD Board

2 94193274010E
©Copyright 2014 Axiomtek Co., Ltd.
Version A1 July 2014
Printed in Taiwan
Assembly Drawing
AX93274 is suggested to be assembled with Pico-ITX PICOxx1 series.
94193274010E 3
©Copyright 2014 Axiomtek Co., Ltd.
Version A1 July 2014
Printed in Taiwan
Quick Start
The procedures required to power on PICOXX1 with AX93274
installed:
(1) Require a PSE which complies with IEEE802.3at standard.
(2) Connect Ethernet Connector CN1 & DC Power out connector CN2/3
to PICOXX1 series via cables.
The choice between CN2 and CN3 depends on the power
input of PICOxx1 series.
Note: there are 80% efficiency for 12V-DC-In PICOxx1 series
while 70% efficiency for 5V-DC-in PICOxx1 series.
(3) Following assembly drawing, Install heatsink, heatspreader,
thermal module and AX93274 I/O board to PICOXX1 series.
(4) Firmly insert the Internet cable to connect LAN1 on AX93274
and PSE. Then power on PSE to start PICOxx1 series.