AXIOMTEK eBOX800-900-FL Series User manual

©Copyright 2018 Axiomtek Co., Ltd.
Version A1 December 2018
Printed in aiwan
9416K800030E
4
M.2 SSD Installation
Step 1 Turn off the system and unplug the power cord.
Step 2 Turn the system upside down to locate screws at the bottom
as red marked and loosen six screws, then remove the bottom
cover.
Step 3 Remove the bottom cover, and locate the M.2 2280 Key M slot
on the board.
Step 4 Holding the M.2 2280 Key M SSD card at a 30 degree angle up
from horizontal, slowly insert the golden fingers into the M.2
2280 Key M slot until it is fully inserted in. And secure the M.2
2280 Key M SSD card to the carrier by tightening up the one
M3*4L screw to the marked position.
※ Tighting torque for HEX socket set screw: 7.5 kgf
※ HEX KEY specifications are shown below:
Note: Please refer to the user’s manual to get more detail information.
eBOX800-900-FL Quick Installation Guide
©Copyright 2018 Axiomtek Co., Ltd.
Version A1 December 2018
Printed in aiwan
9416K800030E
1
Packing List
System Unit x 1
Quick Installation Guide x 1
Screws Pack x 1
Antennas for WLAN x 2
※
※※
※Do not try to apply power to the system if any damaged components.
Dimensions
eBOX800-900-FL Series Embedded System

©Copyright 2018 Axiomtek Co., Ltd.
Version A1 December 2018
Printed in aiwan
9416K800030E
2
I/O Outlets
The following figures show I/O outlets on front of the eBOX800-900-FL.
Top View
Bottom View
© Copyright 2018 Axiomtek Co., Ltd.
Version A1 December 2018
Printed in aiwan
9416K800030E
3
Installation of LTE Mini PCIe Module (half-size)
Step 1 Turn off the system and unplug the power cord.
Step 2 Turn the system upside down to locate screws at the bottom
as red marked and loosen six screws, then remove the bottom
cover. And locate the PCI Express mini card slot on the board.
Step 3 Holding the PCI Express mini card at a 45-degree angle up
from horizontal, slowly insert the golden fingers into the PCI
Express slot until it is fully inserted in. And secure the PCI
Express mini card to the carrier by tightening up the one
M2*5L screw to the marked position.
Step 4 Find the SMA cables from the adhesive backed cord clip
attached at the chassis as picture below.
Step 5 Connect the SMA cables to I-PEX connector of LTE Module
and install LTE Antennas.