AXIOMTEK eBOX625-853-FL User manual

©Copyright 2016 Axiomtek Co., Ltd.
Version A1 April 2016
Printed in Taiwan
9416K625020E
4
Installing the Memory Module
Step 1 Turn the system upside down, loosen screws of bottom cover.
Step 2 Find the DDR3L SO-DIMM position.
Step 3 Locate the memory module, insert the gold colored contact into the
socket.
Step 4 Push the module down, until it is firmly seated by locking two
latches on the sides.
Step 5 Fasten screws of bottom cover then finish the installation.
Note:
Please be informed that you can get more detail information in
eBOX625-853 user’s manual.
eBOX625-853-FL Quick Installation Guide
©Copyright 2016 Axiomtek Co., Ltd.
Version A1 April 2016
Printed in Taiwan
9416K625020E
1
Packing List
System Unit x 1 DVD/CD x 1
Quick Installation Guide x 1 Remote Power cable x 1
Screws Pack x 1 12V/36W adapter & power cord
Optional SSD/HDD Optional Wall-mount Bracket
Optional mSATA Optional VESAMount Kit
Optional Mini Card Modules Optional Din-rail Kit
Optional DDR3L Memory Optional Antenna
Do not try to apply power to the system if any damaged components.
Dimensions
eBOX625-853-FL Series Embedded System

©Copyright 2016 Axiomtek Co., Ltd.
Version A1 April 2016
Printed in Taiwan
9416K625020E
2
I/O Outlets
The following figures show you I/O outlets on front and rear panels of the
eBOX625-853-FL Series.
Front View
Rear View
©Copyright 2016 Axiomtek Co., Ltd.
Version A1 April 2016
Printed in Taiwan
9416K625020E
3
Installing the Hard Disk
Step 1 Turn the system upside down to locate screws at the bottom,
loosen screws.
Step 2 Remove the bottom cover and then prepare your 2.5” HDD/SSD to
assemble with your bottom cover.
Step 3 Please refer to the below photo and you can see some marks on
the surface of bottom cover, assemble your HDD on bottom cover
and notice HDD’s connector position.
Step 4 Assembly the HDD together with the SATAHDD then fasten four
screws of bottom cover. Please note you should check HDD
connector’s position.
Step 5 Connect SATA cable and power cable to SATAHDD.
Step 6 Please fastens screws of bottom cover to complete installation.