AXIOMTEK IPC934-230-FL User manual

4 9416G934010E
©Copyright 2014 Axiomtek Co., Ltd.
Version A1 November 2014
Printed in Taiwan
Step 5 Insert the HDD module into the HDD socket.
IPC934-230-FL Quick Installation Guide
9416G934010E 1
©Copyright 2014 Axiomtek Co., Ltd.
Version A1 November 2014
Printed in Taiwan
Checklist
IPC934-230-FL Series Fanless
System Unit x 1 HDD Bracket x 2
Screw Pack x 1 HDD Mylar x 2
Driver CD x1 Foot Pad x 4
Quick manual x 1 Wall mount bracket x 2
CPU Thermal Pad x 1 19V 150W Adapter (for AC
Version)
Remote switch cable x 1 Terminal block x 1 (for DC
version)
Note: Please do not try to apply power to the system if any damaged
components.
Installing the CPU
Step 1 Turn off the system, and disconnect the power connector.
Step 2 Loosen screws to remove the HS cover from the chassis.
Step 3 After opening the Heat sink cover, you can locate the CPU
socket as marked. Align pins of the CPU with pin holes of
the socket. Be careful of the CPU’s orientation that you
need to align the arrow mark on the CPU with the arrow key
on the socket. Please remove the Mylar before you install
the CPU into the socket.
IPC934-230-FL Industrial and Fanless Computers

2 9416G934010E
©Copyright 2014 Axiomtek Co., Ltd.
Version A1 November 2014
Printed in Taiwan
Installing the Memory Module
Step 1 Turn off the system, and disconnect the power connector.
Step 2 Loosen screws to remove the Heat sink cover from the chassis
Step 3 Install the memory module into the socket and push it firmly
down until it is fully seated. The socket latches are clipped
on to the edges of the SO-DIMM.
Installing the Hard Disk Drive
Step 1 Turn off the system, and disconnect the power connector.
Step 2 Loosen screws to remove the top cover from the chassis.
9416G934010E 3
©Copyright 2014 Axiomtek Co., Ltd.
Version A1 November 2014
Printed in Taiwan
Step 3 Open the top cover and locate the Hard Disk Drives as red
marked.
Step 4 There are 2 thermal pad and 2 HDD brackets in the
accessory box, please sticker the HDD Mylar before
assembly the HDD with the bracket.