AXIOMTEK eBOX560-900-FL Series User manual

©Copyright 2018 Axiomtek Co., Ltd.
Version A1 June 2018
Printed in T iw n
9416K560040E
4
Installing the M.2 2280 M-Key SSD Module
Step 1 Turn off the system, and unplug the power adaptor.
Step 2 Turn the system upside down to locate screws at the bottom
side as red marked and loosen four screws.
Step 3 Remove the bottom cover.
Step 4 Locate the M.2 2280 M-Key slot on the board.
Step 5 Holding the M.2 2280 M-Key SSD card at a 30 degree angle up
from horizontal, slowly insert the golden fingers into the M.2
2280 M-Key slot until it is fully inserted in.
Step 6 Press it down, and secure the M.2 2280 M-Key SSD card to the
carrier by tightening up the M3*4L Phillips flat head screw.
Note: Please refer to the user’s manual to get more detail information.
eBOX560-900-FL Quick Installation Guide
©Copyright 2018 Axiomtek Co., Ltd.
Version A1 June 2018
Printed in T iw n
9416K560040E
1
Packing List
System Unit x 1 EU Power cord x 1 or US Power
cord x 1
Quick Installation Guide x 1 12VDC / 60W AC to DCAdapter x 1
Screws Pack x 1 Foot Pad x 4
 Do not try to apply power to the system if any damaged components.
Dimensions
eBOX560-900-FL Series Embedded S stem

©Copyright 2018 Axiomtek Co., Ltd.
Version A1 June 2018
Printed in T iw n
9416K560040E
2
I/O Outlets
The following figures show you I/O outlets on front and rear panels of the
eBOX560-900-FL Series.
Front View
Rear View
©Copyright 2018 Axiomtek Co., Ltd.
Version A1 June 2018
Printed in T iw n
9416K560040E
3
Installing the PCI Express Mini Card
Step 1 Turn off the system, and unplug the power adaptor.
Step 2 Turn the system upside down to locate screws at the bottom
side as red marked and loosen four screws.
Step 3 Remove the bottom cover.
Step 4 Locate the PCI Express mini card slot on the board.
Step 5 Holding the PCI Express mini card at a 45 degree angle up
from horizontal, slowly insert the golden fingers into the PCI
Express slot until it is fully inserted in.
Step 6 Press it down, and secure the PCI Express mini card to the
carrier by tightening up one M2*5L Phillips pan head screw.