Axis AXIS 215 PTZ-E Instruction sheet

ADDENDUM AXIS 215 PTZ-E Network Camera r1.0 Part no: 34142
How to install audio and I/O cables in AXIS
215 PTZ-E Network Camera
AXIS 215 PTZ-E Network Camera is delivered without hardware support for audio and I/O. However it
is possible to install cables for these.
Important!
•Installing the cables for audio and I/O must be done only by an authorized technician.
•Installing audio and I/O cables will nullify the IP-66 rating and AXIS 215 PTZ-E Net-
work Camera will no longer be suitable for outdoor use.
Follow these steps to install the audio and I/O cables:
.
1. Remove the wall bracket.
2. Remove the sunshield.
cut and remove the rubber gasket.
Caution: Make sure not to damage the cables
3. Unscrew the cable gland;
while removing the rubber gasket. The rubber
gasket is now no longer usable, and the IP-66 rating
is no longer valid.
4. Remove the top by
unscrewing 3 screws.

ADDENDUM AXIS 215 PTZ-E Network Camera r1.0 Part no: 34142
7. Pull the I/O or audio cable through the casing
and cable gland to the camera connection.
For more information on how to connect I/O and
audio, please refer to the AXIS 215 PTZ Network
Camera’s user manual delivered with this pack.
9. Work backwards from step 6 to re-assemble
the parts.
5. Remove the
loosening
dome by
the 4 screws.
6. Remove the black (fan-and-
heater) ring by unscrewing
4 screws.