Aztech HW550 User manual

ADSL Routers Configuration
Page 1of 7
How to configure Internet on Aztech HW-550 3G?
Aztech-HW550
Connecting to the Internet:
To Connect to the Internet via the Web User Interface:
1. Open your Internet web browser.
2. Type http://192.168.2.1 in the address bar and press enter. This opens the login authentication
page.
3. Type your Username and Password. Your default Username and Password is admin/admin.
4. Click the Wizard Tab then Follow the step-by-step guide on how to setup the router.
5. Select the Language and Time zone from the drop down box then click Next to continue.

ADSL Routers Configuration
Page 2of 7
6. Select the Internet Connection type then click Next to Continue.
If you choose UMTS (3G), you are required to have the following:
- USB Modem Stick
- Broadband data SIM card
If you choose WAN, you are required to have the following:
- DSL or cable modem.
Active Internet Account

ADSL Routers Configuration
Page 3of 7
7. UMTS 3G connection
Please connect your USB modem stick to HW550-3G and make sure that your data SIM
card is properly inserted into the modem.
- Access Point Settings –Choose between List and Manual. List will provide the APN set
by your Internet Service Provider. Choose your Country, Internet Service Operator and
the APN. Manual you need to manually key in the APN provided by your ISP. Some ISP
may require a different name for your APN. Please contact your ISP if you don’t have
this information.
- Username and Password –Some ISP may require a Username and Password set by the
Operators. Please contact your ISP if you don’t have this information Choose your
preferred Connection Method.

ADSL Routers Configuration
Page 4of 7
- Connect Manually –This connection method requires you to manually press the
‘Connect’ button each time Internet connection is required. Please note that the
Internet connection will not be disconnected unless you manually press the ‘Disconnect’
button.
Always connected –This connection method allows your Internet connection to be
always ON. You need to manually press the ‘Disconnect’ button when Internet
connection is not required.
8. WAN Connection
Please connect your DSL or Cable modem to HW550-3G WAN port using an Ethernet
cable, make sure that you have an active Internet account. Connection Type
Static IP –select this if your ISP provides you the IP address, Subnet mask, Gateway and
DNS server addresses.
- DHCP - if you select this your HW550-3G will automatically get an IP address from the
DHCP server or from your ISP.

ADSL Routers Configuration
Page 5of 7
PPPoE –select this if your ISP provides you the Username and Password for you to
connect to the Internet.
9. Setup your wireless connection, tick Wireless Enabled to activate your wireless connection and
set the SSID for your HW550-3G. Click Next to continue.

ADSL Routers Configuration
Page 6of 7
10.Under Summary page verify the settings made then click ‘Apply’ for the settings to take effect.

ADSL Routers Configuration
Page 7of 7