Baby Jogger CITY MINI GT double User manual

Read these instructions carefully
before use and keep them for
future reference. Your child’s
safety may be affected if you do
not follow these instructions.
www.babyjogger.com
CITY MINI GT DOUBLE
ASSEMBLY INSTRUCTIONS

22
• This stroller is not suitable for jogging, running, skating or rollerblading.
• Never leave children unattended.
• Prevent serious injury to your children by always using the safety harnesses.
• Child may slip into leg openings and strangle. Never use in reclined carriage position
unless safety harness is properly fastened.
• Parcels or accessory items, or both, placed on the stroller may cause the stroller to
become unstable.
• Any load attached to the handle affects the stability of the stroller.
• Recommended weight for each seat back pocket is 2 lbs and basket is 10 lbs.
Excessive weight may cause a hazardous unstable condition to exist.
• This stroller seats two passengers.
• This stroller is suitable from birth to 5 years (maximum weight: 50 lbs in each seat unit).
• Total weight load recommended for this stroller is 114 lbs (50 lbs in each seat unit, 2 lbs
in each seat back pocket, 10 lbs in basket).
• Stroller is not meant to be used for transporting children up or down stairs. Damage
resulting to stroller, will not be covered under warranty.
• Accessories which are not approved by the manufacturer or distributor shall not be used.
• The passengers shall remain seated (no standing in the stroller).
• Watch out for cars – never assume that a driver can see you and your children.
• It may be unsafe to use replacement parts other than those supplied or approved
by the manufacturer.
For the sake of your precious cargo, please read
these WARNINGs before using your stroller.
WARNING:

11
1 Unpack stroller from box and set
wheels aside.
3 Turn stroller over to upright position.
2 Begin to unfold stroller by pulling the Auto-lock lever
while pushing the handle up and away from the lower
frame. The stroller will click into place.
4 Snap red safety strap to frame under the fold
mechanism before use.
FRAME
Warning: Ensure all locking devices are engaged before use.
Warning: Always be sure the safety strap is securely snapped
onto the frame before using stroller.

2
FRONT WHEEL
1 To install front wheel, lay stroller back so the handle is resting on floor.
2 Attach the front wheel by sliding the axle into the wheel end until it clicks.
Gently tug on wheel to make sure the front wheel is locked into place.
Swivel/Straight Feature
• Press the lever down to allow the front wheel assembly to swivel.
• Raise the lever up to lock the front wheel assembly in the straight position for long distance strolling.
NOTE: • When loading and unloading child, always press the lever down to lock the front wheel straight.
• Although the front wheel of your City Mini GT locks it is not intended for jogging or exercise purposes.
CLICK

3
REAR WHEELS
1 Align wheel axle with wheel mount on stroller frame.
2 Insert the wheel axle into the wheel mount until it clicks into place.
Gently tug on wheel to make sure the rear wheel is properly attached.
To install rear wheels:
1 Press the wheel release button while gently sliding the wheel
away from the wheel mount.
To remove the rear wheels:

4
2 Slide middle canopy bracket
into canopy bracket located in
the seat opening in the center
of the stroller frame until you
hear it click into place.
3 At the top of the canopy, wrap
canopy flap around the handle
crossbar and attach Velcro.
1 Slide outer canopy peg into
the top hole of the universal
mounting bracket until
you hear it click into place.
(The bottom hole can be
used to attach Baby Jogger
accessories to your stroller).
CANOPY
To attach canopy to frame:
To remove the canopy:
1 Press gray button to release the
canopy peg from the universal
mounting bracket and unfasten
all Velcro at the top of the
canopy.
CLICK

5
BRAKE
To engage parking brake: Gently pull brake lever into upright position
until it clicks into place.
To release parking brake: Pinch gray tabs and pull towards you. Push brake lever down until it is parallel with
the frame.
Warning: Engage parking device before loading and unloading passenger.

66
1 Unclip top of shoulder strap
from the seat and re-clip on
the pair of seat loops closest
to child’s shoulder height.
1 Pull shoulder pads down close to main harness buckle.
2Hold the plastic guide and pull the strap end to tighten or pull
the upper harness strap to loosen.
3 Fasten both shoulder strap buckles
into the crotch strap buckle. The
buckles should always be clicked
into place before use.
SAFETY HARNESS
To adjust harness height: To adjust harness length:
Warning:
Always use the
crotch strap in
combination with
the shoulder straps
and waist belt.
To buckle: To unbuckle:
4 Press both sides of the
shoulder buckles to release
them from the crotch buckle.
Warning:
Avoid serious
injury from falling
or sliding out.
Always properly
adjust and fasten
safety harness.

7
1 Pinch the clamp behind the seat, and slide it down to desired recline. Pull seat down on both sides
to match recline position of clamp. Reverse steps to return to the upright position.
Weather Cover: If desired, pull weather
cover down and over the seat back mesh.
Secure firmly over both sides of seat.
When not in use, roll weather cover up
and fasten with elastic loop and barrel
provided under top of the canopy fabric.
SEAT RECLINE
To recline:

8
To remove the basket:
1 From the rear of the stroller: Unsnap the top
snaps of the basket from around the frame
tubing above the middle crossbar. Unsnap
the bottom snaps of the basket from around
the frame tubing below the middle crossbar.
2 From the front of the stroller: Unsnap lower
seat fabric to expose the bottom front
portion of frame. Unfasten basket Velcro
from around the frame tubing. Snap seat
fabric to frame once complete.
BASKET
The basket of your City Mini GT comes fully attached.