B&D TRI-TRAN KPX-7 User manual

Press the MODE button
until the TRANSMIT LED is
lit. Press and HOLD the
button and go to STEP 2.
Press the CODE SET
button and release.
OR
ACTIVATE: The CODE SET mode on the garage door
opener by;
The garage door opener will indicate that CODE SET
has been completed.
STEP TWO
CREATE YOUR OWN PIN
OPEN THE PACKAGING
STEP ONE
CODE IN THE KEYPAD
tip
FACTORY PIN: Keep in
safe place and retain
for future use.
FACTORY
PIN 1Release
for 2 secs 1
Enter
HOLD button 1
for 2 secs
HOLD again
for 2 secs
Pressing Button 1 again within 10 seconds will
control the garage door again.
STEP THREE
CONTROLLING THE GARAGE DOOR
FACTORY
PIN 1
Enter
Press and HOLD
button 1
Until door starts
to operate
This PIN will now operate the keypad instead of
FACTORY PIN. Keep the FACTORY PIN in safe place
as this is required to FACTORY RESET the keypad.
STEP FOUR
FACTORY
PIN 1FCN
Enter
Use number
buttons & enter
a 4 digit PIN
Enter your
new PIN
FCN FCN YOUR
PIN
YOUR
PIN FCN
Press Press Press Press Press

ADDING ADDITIONAL PINS
The Keypad will give a long beep to indicate the
PIN has been accepted.
The new PIN can now operate the door.
EXISTING
PIN 2FCN
Enter
Use number
buttons & enter
a 4 digit PIN
Enter your
new PIN
FCN FCN NEW
PIN
NEW
PIN FCN
Press Press Press Press Press
All users can now enter their PIN followed by the
programmed number button to control device.
CODE SET OTHER KEYPAD BUTTONS
1-8 Release
for 2 secs 1-8
Enter
HOLD a button
1-8 for 2 secs
HOLD same button
again
for 2 secs
2nd Garage
Gate
PIN
CHANGING A PIN
The new PIN can now operate the door.
EXISTING
PIN 4FCN
Enter
Enter your
new PIN
FCN FCN NEW
PIN
NEW
PIN FCN
Press Press Press Press Press
Enter your
new PIN
DELETING A PIN
EXISTING
PIN 4FCN
Enter
Enter
FCN FCN 0000 FCN
Press Press Press Press Press
Enter
0000
NOTE: If the last PIN in the memory is deleted then
the keypad is factory reset.
Refer to CREATE YOUR OWN PIN to start again.
refer to bnd.com.au for extended programming
tip
Three long beeps after pressing button 2, indicates
memory is full.
The Keypad buttons can be programmed to
operate other functions or devices.
ACTIVATE: The CODE SET mode on the garage door or device
Up to 29 additional PINs can be added