BBC Bircher XRF-TI User manual

1
XRF-TI
LED
2x
18
194
174
190
4.54.5
18


Transmitter for wireless signal transmission system for safety edges
Original operating instructions
Intended use: Monitoring safety edges on doors and gates, in combination with the XRF-Rx receiver
ENGLISH
404301D
09/20
 Carefully pull out
the PCB
 Loosen screw
(at original delivery
shipped in bag with
Philips screw driver #00)
 Plug in connector
Pairing is possible with open transmitter or later in mounted situation.
After initiating pairing on Rx
(see receiver manual),
press button
After initiating pairing on Rx (see receiver manual),
press the edge two times within 2 sec.
 Pairing (1.2) if required
 Slide in the PCB again
 Close the housing, tighten the screw (Philips #00, shipped with unit)
 LED ashes 5x (conrms battery connected)
Delivery state Battery connected
1.1 Connect battery
1.2.a Pairing at open state 1.2.b Pairing at built-in state
1.2 Pairing
1Set-up
Battery 3.6. VButton
Screw
Button
Note:
Position of
red wire
Note:
Alignment of battery,
position of wire
PCB
Cable
with
plug
Wire

2
OK?
3x
Designed in Switzerland / Made in China
BBC Bircher Smart Access, BBC Bircher AG, Wiesengasse 20, CH-8222 Beringen, www.bircher.com
OK?
XRF-TI
Slide in the PCB
Close the cover again
System test mandatory!
Dispose battery acc. to local regulations
 Order new battery (prepared with connector)
Pull out the PCB (see 1.1.)
 Disconnect battery plug and remove battery
 Insert new battery, plug in connector
2Trouble shooting
2.1 Warning indicator for low battery voltage
1.4 System check
2.2 Battery change
Check the system
by pressing the safety edge
Every minute
Receiver
Beep
3Technical data
Input 8.2 kOhm
Battery power 1x Lithium Inorganic 3.6 V
Battery life Up to 7 years
Operating frequency 868.3 MHz
4EU Declaration of Conformity
6Contact
5WEEE
Devices with this symbol must be treated separately during disposal. This must be done in accordance with the laws of
the respective countries for environmentally sound disposal, processing and recycling of electrical and electronic equipment.
XRF-TI is designed for the concealed installation in
the contact proles of ExpertSystem (see assembly
and mounting instruction).
However it can be wired with other saftey edges
eg. where space is limitted.
The LED ashes when activating the sensor element (pressing the sensing edge)
and ashes again when releasing the sensor element.
Does the door/gate stop when the sensing element is activated?
1.3 Mounting
Sensing
edge
Built-in
(e.g. sliding gate)
Surface mount
(e.g. industrial door with ClickLine)
To nd out which
transmitter has low
battery: Press each edge.
Battery good Battery bad
Beep
Sensing edge
XL