BE Power Equipment HW2765HG User manual
OPERATOR'S MANUAL
HOT WATER PRESSURE WASHER
HW4013HGHW2765HG HW4013HBG HW4015RA
10/2021 - BE Power Equipment Inc. 85.610.476
INDUSTRIAL
2BEPOWEREQUIPMENT.COM
TABLE OF CONTENTS
INTRODUCTION
IMPORTANT SAFETY WARNINGS
GENERAL INFORMATION
SET-UP
OPERATION
MAINTENANCE
UNIT BREAKDOWNS
TROUBLESHOOTING
WARRANTY
BEPOWEREQUIPMENT.COM 3
INTRODUCTION & PRODUCT INFO
Using the Operator's manual
Record Identication Numbers
(1-866-850-6662).
Date of Purchase:
Dealer Name:
Dealer Phone:
PRODUCT IDENTIFICATION NUMBERS
Model Number:
Serial Number:
ATTENTION:
4BEPOWEREQUIPMENT.COM
IMPORTANT SAFETY WARNINGS
This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
DANGER
WARNING
CAUTION
NOTICE
HAZARD SYMBOLS AND MEANINGS
DANGER
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
BEPOWEREQUIPMENT.COM 5
IMPORTANT SAFETY WARNINGS
WARNING
•
•
WARNING
•
•
WARNING
•
•
•
•
•
•
•
•
•
WARNING
•
•
6BEPOWEREQUIPMENT.COM
WARNING
•
WARNING
•
•
WARNING
•
•
•
•
•
WARNING
•
•
•
•
•
•
•
•
•
•
•
•
•
•
IMPORTANT SAFETY WARNINGS
BEPOWEREQUIPMENT.COM 7
GENERAL INFORMATION
DESCRIPTION HW2765HG HW4015RA HW4013HG HW4013HBG
Series
Max PSI
GPM
Engine
Engine Displacement
Engine Start
Drive System
Pump Model
Pump Unloader
Soap Injector
Burner Type
Max Temperature
Burner Fuel Type
Burner Fuel Tank
Burner Fuel Consumption
Double Wire Braided Hose
Spray Nozzles Included
Spray Gun Wand
12v DC Oil-red burner
HEATING COIL
Stainless-steel coil
skin
13" heavy-duty
Mounting bracket
roll-cage powder
coated 1.5" OD
American made
Adjustable thermostat
meter
3/4" HD Threaded
Marine sealed battery
Brake assembly
12" oil drain hose
5-year warranty
Honda GX390
10-Gallon, removable,
rust-proof
polyethylene
fuel tank
8BEPOWEREQUIPMENT.COM
SET-UP
WATER SUPPLY
1.
2.
4. Never allow the unit to operate without the water hose attached and the water supply opened all
the way.
NOTICE
•
Pumps are water cooled.
Do not let the machine run for more than 30
seconds without pulling the trigger.
thermal valve.
UNLESS OTHERWISE SPECIFIED:
CHECKED
SIZE
APPLICATION
TITLE:
PROPRIETARY AND CONFIDENTIAL
INTERPRET GEOMETRIC
TOLERANCING PER:
Q.A.
FINISH
DWG. NO.
DATE
USED ON
A
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL
ANGULAR: MACH
BEND
TWO PLACE DECIMAL
THREE PLACE DECIMAL
NEXT ASSY
MATERIAL
NAME
REV
DO NOT SCALE DRAWING
SCALE: 1:2
TSF2021
ENG APPR.
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
<INSERT COMPANY NAME HERE>. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
<INSERT COMPANY NAME HERE> IS
PROHIBITED.
COMMENTS:
DRAWN
MFG APPR.
SHEET 1 OF 1
2 1
A
B
A
B
12
<COMPANY NAME>
BEPOWEREQUIPMENT.COM 9
SET-UP
HOW TO USE SPRAY TIPS
FOLLOW THESE INSTRUCTIONS TO CHANGE SPRAY TIPS:
1.
2.
•
•
•
•
• No other spray tip will draw soap
USAGE TIPS
•
•
Do not use the red spray tip on glass.
0o
RED 40o
WHITE Soaper
BLACK
15o
YELLOW 25o
GREEN
10 BEPOWEREQUIPMENT.COM
PRE-OPERATION SAFETY
1.
2.
A.
B.
MANUAL & SAFETY REVIEW
1.
2.
START-UP PROCEDURE PREPARATION
1. SAE 10W30
SAE 30
2.
If a fuel leak is found, do not start the unit.
If a cut or leak is found, do not use the hose.
OPERATION
BEPOWEREQUIPMENT.COM 11
START-UP (COLD WATER)
1.
2.
Spray Tips
NOTICE
Damage caused by running the pump without water is
not covered by warranty.
OPERATION
12 BEPOWEREQUIPMENT.COM
IMPORTANT:
Regardless of the starting method, remember to gradually move the choke lever back to the "open"
position once the engine is running.
*Pump Uses SAE30
Non-Detergent Mineral Oil A
*Engine Uses SAE 10W30 Oil
OPERATION
BEPOWEREQUIPMENT.COM 13
WARNING
NOTICE
1.
2.
APPLYING DETERGENT
HOTWATERBURNERSTARTUPPROCEDURE
NOTICE
OPERATION
BRASS- STAINLESS STEEL
LOW PRESSURE CHEMICAL
INJECTOR, 4000PSI, 2.5GPM,
3/8"QC, 3/8:" PLUG
DO NOT SCALE DRAWING
85.400.001(R2)
SHEET 1 OF 1
10/04/19
HAMID L
UNLESS OTHERWISE SPECIFIED:
SCALE: 1.5:1
WEIGHT:
REV
DWG. NO.
B
SIZE
TITLE:
NAME
DATE
COMMENTS:
Q.A.
MFG APPR.
ENG APPR.
CHECKED
DRAWN
FINISH
MATERIAL
INTERPRET GEOMETRIC
TOLERANCING PER:
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL
ANGULAR: MACH
BEND
TWO PLACE DECIMAL
THREE PLACE DECIMAL
APPLICATION
USED ON
NEXT ASSY
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
<INSERT COMPANY NAME HERE>. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
<INSERT COMPANY NAME HERE> IS
PROHIBITED.
A A
B B
4
4
3
3
2
2
1
1
HOUR METER
THERMOSTAT BURNER
ON
OFF
TACH / HOUR
OFF
21
14 BEPOWEREQUIPMENT.COM
CAUTION
SHUTTING THE UNIT DOWN
1.
2.
STORAGE & WINTERIZING
• BE "Pump Saver"(P/N: 85.490.046).
Freezing damage is not covered by warranty.
• BE "Pump & Coil Blowout Tool" (P/N: 59.400.000).
OPERATION
NOTICE
1.
2.
WARNING
•
•
BEPOWEREQUIPMENT.COM 15
SPECIFIC MAINTENANCE
ENGINE:
PUMP:
Use SAE 30 non-detergent pump oil
NOZZLE:
PRESSURE WASHER PUMP & COIL SAVER TOOL
MAINTENANCE
Sight
Glass
PUMP INLET
16 BEPOWEREQUIPMENT.COM
MAINTENANCE
MAINTENANCE SCHEDULE
*
**
***
****
*****
PROCEDURE DAILY 3 MONTHS 6 MONTHS 9 MONTHS 12 MONTHS
*****
**
***
*
*
*
*
*
*
****
BEPOWEREQUIPMENT.COM 17
BURNER BREAKDOWNS
ADC BECKETT FOR HW4015RA, HW4013HG, HW4013HBG
MSR-DC WAYNE FOR HW2765HG
2
1
4
6
5
3
7
9
8
ITEM #. PART #. DESCRIPTION
1
2
ITEM #. PART #. DESCRIPTION
1
2
1
2
18 BEPOWEREQUIPMENT.COM
UNITBREAKDOWN
Control Panel
1
12
2
10
11
20
BEPOWEREQUIPMENT.COM 19
PARTSREFERENCELIST
ITEM PART NUMBER DESCRIPTION Q T Y.
1 1
2 1
1
1
1
1
1
1
1
10 1
11 1
12 1
1
1
1
1
1
1
ACCESSORIES
20
20 BEPOWEREQUIPMENT.COM
UNITBREAKDOWN
HOUR METER
THERMOSTAT BURNER
ON
OFF
TACH / HOUR
OFF
21
3
4
5
6
2
9
15 12
1
10
13
17
7
11
8
This manual suits for next models
3
Table of contents
Languages:
Other BE Power Equipment Pressure Washer manuals
BE Power Equipment
BE Power Equipment P2115EN User manual
BE Power Equipment
BE Power Equipment HW4013HBG Manual
BE Power Equipment
BE Power Equipment COMMERCIAL Series User manual
BE Power Equipment
BE Power Equipment P1515EPN User manual
BE Power Equipment
BE Power Equipment P1815EN User manual
BE Power Equipment
BE Power Equipment HW152EMD User manual
BE Power Equipment
BE Power Equipment HW4013HBG Service manual
BE Power Equipment
BE Power Equipment P1915EN User manual
BE Power Equipment
BE Power Equipment HW3024HG12V User manual
BE Power Equipment
BE Power Equipment P1515EPNW User manual
