Beam RST215 User manual

Installation Guide for Beam Magnetic Single Mode Antenna (RST215)
Magnetic Single Mode Antenna (includes 5 m / 16.4 ft Cable)
Installation Guide for Beam Magnetic
Single Mode Antenna (RST215)
For more information please visit: beamcommunications.com
Package Contents
Antenna installation is critical for optimum performance of your Iridium service.
Installation Guidelines
To ensure maximum performance of the antenna system and to maximise availability and reliability of service the
antenna must;
• mount antenna horizontally (top side facing up)
• have a clear line of site to the sky
• be clear and free of obstructions
• be located away from other transmitting devices
• be securely attached to a at ferrous surface
• be located outdoors
• be installed with a Beam certied cable
Installing Antenna Cables
When installing antenna cables, follow these guidelines:
• Route and restrain cables to prevent them from vibrating or moving under normal conditions, which could result in
damage to the antenna or the coaxial cable connections.
• Wherever the cables contact structures, protect the cables from chang or abrasion. If a cable needs to be bent, avoid
kinking it, and ensure that each bend radius follow the cable specication limits.
Applications
VEHICLE RAIL TRUCK
Recommended Antenna Installation location

For more information, please scan the barcode or visit beamcommunications.com
030187 R01
Antenna Installation
1. Choose the appropriate location for the antenna (front or back, depending on the placement of your Beam Iridium
terminal or accessory). Recommended location is on a ferrous surface of the vehicle away from roof racks or other
antennas, where the antenna can be on a at and clean surface.
2. Route the cable through the door’s rubber seal, not through the window. The rubber seal is soft which can create a
seal around the cable preventing water from leaking into the cabin. At the same time, the soft rubber will not crush
the cable.
3. Route the cables inside the cabin and ensure that the Iridium connector is attached to the corresponding connector
of the Beam Iridium terminal or accessory.
4. To remove the antenna, avoid pulling the cable, instead hold the antenna as shown with one hand and pull antenna
up from the metal surface. Do not slide across to avoid scratching the surface.