Beghelli BBX-SE User manual

BBX-SE
BBX-SE-HO
Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: [phone]
9/16/22
One blink ON/pause (4 seconds) Battery is not connected
Two blinks ON/pause (4 seconds) Battery is shorted or battery voltage drops below acceptable level
Three blinks ON/pause (4 seconds) Charger board circuit fault
Four blinks ON/pause (4 seconds) Transfer circuit fault
Five blinks ON/pause (4 seconds) Emergency lamp fault
Six blinks ON/pause (4 seconds) Remote head’s emergency lamp fault (if installed)
3. For manual test, press test button as follows:
Press test button once (within 2 seconds) 30 seconds test
Press test button twice (within 2 seconds) 3 minutes test
Press test button 3 times (within 2 seconds) 30 minutes test
Press test button 4 times (within 2 seconds) 90 minutes test
1.Install the BBX/ BBX-HO according to the installation instructions.
2. When AC power is supplied to fixture, the unit will automatically initiate a self-test with self-
diagnostics that will do the following:
(1) Monitor for faults with battery, charger board, lamps and transfer circuit every 5 seconds.
(2) Perform a three-minute self-test every month.
(3) Perform a 90-minute self-test every 12 months starting in the 12th month after installation.
Note: ALL functions are factory pre-set (does not need field adjustment).
3. Dual color LED lamp indicator shows the following status:
(1) Green color: ON/ Ready
Blinking: Testing
(2) Red color: Service Alert
Blinking: Sequence below determines service required
TO RESET:
After resolving the fault of emergency equipment, press test button for 2seconds without releasing
to reset. LED indicator will show green.
Page 1 of 2

BBX-SE
BBX-SE-HO
Page 2of 2
Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: [phone]
04/21/22
4. Autotest of Remote Lamps (when applicable):
In order to connect remote lamp heads to Autotest circuit, follow these instructions.
(1) Remove ground male connector from the
female connector.
(2) Plug the remote male connector into the
female connector.
(3) Connect extended remote head wires to
the remote wires using wire nuts. Yellow
is positive(+) and Purple is negative(-).
WARNING
1) Make sure that power is off before making any electrical connections!!
2) Unused wires must be capped using wire nuts.
AC INPUT
White Neutral
Black 120-277VAC
Integral
LED Head
Remote Heads
(Option)
Battery
Ground