Beghelli TEMPESTA PLUS HT User manual

INSTRUCTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
CAUTION! ALWAYS MAKE SURE THE POWER IS TURNED OFF before starting the installation.
1. Measure, locate fixture’s position, and mark locations for the brackets.
2. Secure brackets to ceiling as shown below. (HARDWARE BY OTHERS)
3. Wiring fixture to power supply, shall be performed by a certified electrician, and wired in a manner that
complies with all local and national electrical codes, as well as the manufacturer’s wiring diagram.
4. Proper replacement of a part removed for user manintenance.
TEMPESTA PLUS (TA PLUS-LED)
HT UNV
TM
Beghelli U.S.A., 3250 Corporate Way, Miramar, Florida, Tel: [phone] Tel: [phone] Fax: [phone]
9/16/2019
Page 1 of 3
WIRING

Beghelli U.S.A., 3250 Corporate Way, Miramar, Florida, Tel: [phone] Tel: [phone] Fax: [phone]
9/16/2019Page 2 of 3
A.
A
Using a at head screwdriver,
push-in to release lock (repeat
for 3 other clips).
REMOVING LENS
REMOVING ELECTRICAL ASSEMBLY
B
C
B.C.
Using a at head screwdriver,
twist to release lock (repeat
for 3 other clips).
Install back plate on the wall
at designated location (hard-
ware by others).
(HARDWARE BY OTHERS)
(2) 1/2” TRADE SIZE KNOCK-OUTS

CEILING MOUNT LED POSITIONWALL MOUNT LED POSITION
MOUNTING POSITIONS
Beghelli U.S.A., 3250 Corporate Way, Miramar, Florida, Tel: [phone] Tel: [phone] Fax: [phone]
9/16/2019Page 3 of 3