Behringer DUAL DIAPHRAGM CONDENSER MICROPHONE B-2 PRO User manual

Technical Specifications
The information contained in this sheet is subject to change without notice. No part of this sheet may be reproduced or transmitted in
any form or by any means, electronic or mechanical, including photocopying and recording of any kind, for any purpose, without the
express written permission of BEH INGE Spezielle Studiotechnik GmbH.
BEH INGE is a registered trademark. ALL IGHTS ESE VED.
© 2002 BEH INGE Spezielle Studiotechnik GmbH.
BEH INGE Spezielle Studiotechnik GmbH, Hanns-Martin-Schleyer-Str. 36-38, 47877 Willich-Münchheide II, Germany
Tel. [phone] / 92 06-0, Fax [phone] / 92 06-30
Transducer type: condenser, 1" dual-diaphragm
Operating principle: pressure gradient
Polar pattern: cardioid, omnidirectional or figure eight
Connection: gold-plated balanced XL connector
Open circuit sensitivity (at 1 kHz): cardioid: -36 dBV (0 dBV = 1 V/Pa), 16 mV/Pa
omnidir.: -37 dBV (0 dBV = 1 V/Pa), 14 mV/Pa
figure eight: -35 dBV (0 dBV = 1 V/Pa), 18 mV/Pa
Frequency response: 20 Hz - 20 kHz
Level attenuation: -10 dB (switchable)
Low-Cut filter: 6 dB/oct. at 150 Hz (switchable)
Max. SPL (1% THD @ 1 kHz): cardioid: 138 dB (0 dB), 148 dB (-10 dB)
omnidir.: 139 dB (0 dB), 149 dB (-10 dB)
figure eight: 137 dB (0 dB), 147 dB (-10 dB)
Equivalent SPL (IEC 651): 17 dB-A (cardioid)
18 dB-A (omnidirectional)
16 dB-A (figure eight)
Signal-to-noise ratio: 77 dB, A-weighted (cardioid)
76 dB, A-weighted (omnidirectional)
78 dB, A-weighted (figure eight)
Nominal impedance: <100 Ω
Load impedance: >1 kΩ
Supply voltage: +48 V
Supply current: 3 mA
Dimensions: ∅ head: 56 mm, ∅ shaft: 50 mm, length: 210 mm
Weight: approx. 0.55 kg
STUDIO CONDENSER MICROPHONE B-2 PRO
ENGLISH
Version 1.0 September 2002
www.behringer.com

Polar pattern (cardioid) Frequency response (cardioid)
Polar pattern (omnidirectional) Frequency response (omnidirectional)
Polar pattern (figure eight) Frequency response (figure eight)
BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modifications may be
made from time to time to e isting products without prior notice. Specifications and appearance may differ from those listed or
illustrated.