Belkin F5D4081 User manual

Max. 300m
VideoLink 3
Powerline Internet Adapter
Installing and Setting Up the Adapter
1. Plug the Adapters into power outlets;
one in the room with your other network
equipment, and the other in a room
where you would like to have network
access. When the Adapters recognize one
another, their Powerline Link lights
will glow.
Note: Do not plug the Adapter into a
power strip; doing so may degrade
network performance.
2. Connect one of the Adapters to your
existing modem or router with a network
cable. Use a second network cable to
connect the other Adapter to an Internet
TV, Blu-ray®player, computer, or other
network device such as a wireless access
point, set-top box, or gaming console.
Belkin VideoLink 3 Powerline Internet Adapters allow you to extend your network over your home’s
existing wiring.
Quick Installation Guide
Knowing Your Belkin
VideoLink 3 Powerline
Internet Adapter
Power LED (Right)
Solid Green – Power on
Off – Power off
Blinking Green – During
encryption setup
Solid Green – Encryption
setup successful
Double Flash – Fail in encryption
Powerline Link LED (Middle)
Blinking – Powerline data
transmitting or receiving
Color Green – Link rate excellent:
greater than 80Mbps
Color Amber – Link rate low:
less than 80Mbps
Off – No activity
Ethernet Link LED (Left)
Solid Green – 10/100Mbps port linked
Off – No Ethernet link

Belkin provides free technical support via phone and the Web.
However, we encourage you to attempt (or retry) Steps 1 and 2
before contacting Support.
If you’re still having trouble, contact Belkin Support.
North America http://www.belkin.com
Click on Support Center > Networking Support
UK http://www.belkin.com/uk/
Click on Support Centre > Networking Support
Australia http://www.belkin.com/au/
Click on Support Centre
New Zealand http://www.belkin.com/au/
Click on Support Centre
Support
F5D4081
8820-00771 Rev. A00
© 2011 Belkin International, Inc. All rights reserved. All trade names
are registered trademarks of respective manufacturers listed.
3. (optional) For greater security, use the
security button atop each Adapter:
a) While both Adapters are plugged in,
press the security button atop both
units for 10 seconds (not necessarily
at the same time). The Security lights
will blink.
b) Next, press the security button on one
Adapter for about two seconds.
c) Within two minutes, press the security
button on the other Adapter for about
two seconds. The new password has
now been saved to the second Adapter.
d) To add VideoLink 3 Powerline Internet
Adapters to your secure network,
repeat steps b) and c) beginning with
one of the Adapters that is already on
your secure network.
Installation is complete. If step 3 was not
done, you may add VideoLink 3 Powerline
Internet Adapters to the network by
plugging them in.