Belkin OmniView F1DP108Gea User manual

Start Here
Quick Installation Guide
F1DP108Gea
F1DP116Gea
OmniView
®
SMB
KVM-over-IP Switch
EN
FR
DE
NL
IT
ES

To install the Switch, you will need the following:
Introduction
1
Introduction
This Quick Installation Guide will guide you through the steps needed to
install the OmniView SMB KVM-over-IP Switch (the Switch). If you have
any problems during this installation, please refer to the User Manual.
IEC Power Cord
(included)
OmniView SMB
KVM-over-IP
Switch (included)
Rack-Mount
Brackets with
Screws (included)
VGA Monitor
PS/2 Keyboard
LAN Cable
PS/2 Mouse

Mount the Switch
2
The SMB KVM-over-IP Switch includes adjustable mounting brackets ideal for
installation in 19-inch racks. The mounting brackets feature three adjustment positions
to allow you to set the Switch’s face flush with the ends of the rails or to extend the
Switch past the front of the rails. Please follow these simple steps to achieve the
desired adjustment.
1.1
Determine how far you would like the Switch to protrude from the rack. Select a
bracket-hole scheme.
1.2
Attach the bracket to the side of the Switch using the Phillips screws provided.
(Refer to diagram below.)
Step 1
Mount the Switch
EN

Mount the Switch
3
1.3
Mount the Switch to the rack rails. (Refer to diagram below.)
Your Switch is now mounted securely to the rack and you are ready to
connect the console.

Connect the Console
4
2.1
Connect your monitor VGA cable to the VGA port on the back of the Switch in
the “Console” section. (Refer to diagram below.)
Step 2
Connect the Console
 
  

EN

2.2
Connect your keyboard and mouse PS/2 cables to the PS/2 keyboard and mouse
ports on the back of the Switch in the “Console” section. (Refer to diagram below.)
2.3
Locate and connect a cable from your local area network to the RJ45 Ethernet port
on the back of the Switch. (Refer to diagram below.)
Connect the Console
5
 
  

 
  


2.4
Attach the power cord to the IEC power jack on the back of the Switch,
and power up the Switch. (Refer to diagram below.)
To connect servers to your Switch and to confi gure the Switch for remote
access, please refer to the “Local Installation” and “Remote Installation”
sections in the User Manual.
Connect the Console
6
 
  

EN

© 2006 Belkin Corporation. All rights reserved. All trade names
are registered trademarks of respective manufacturers listed.
P75217ea
OmniView
®
SMB
KVM-over-IP Switch
Belkin Ltd.
Express Business Park, Shipton Way
Rushden NN10 6GL
United Kingdom
[phone]
[phone] fax
Belkin B.V.
Boeing Avenue 333
1119 PH Schiphol-Rijk
Netherlands
[phone]
[phone] fax
Belkin GmbH
Hanebergstrasse 2
80637 Munich
Germany
[phone]
[phone] fax
Belkin Tech Support
Europe: 00 800 223 55 460
Belkin SAS
130, rue de Silly
92100 Boulogne-Billancourt
France
[phone]
[phone] fax
Belkin Iberia
Avda. Cerro del Aguila 3
28700 San Sebastián de los Reyes
Spain
[phone]
[phone] fax
Belkin Nordic
Knarrarnäsgatan 7
164 40 Kista
Sweden
[phone]
[phone] fax