Bell'O SP-224 User manual

© 2002 Bell'O International, LLC
Bell’O International Corp. will not be responsible for failure to assemble as directed or for the improper assembly, use or handling of this stand.
Bell’O International Corp.
711 Ginesi Drive
Morganvi e, NJ 07751-1235
Customer Service: [phone]
E-mai : support@be o.com
Web: www.be o.com
SP-224
ASSEMBLY INSTRUCTIONS
Italian Designed • Made in China
8x
8 x
8x
4x
4 x
1 x
4 x
M-1
A. Place the two curved base sections (2 & 3)
on floor against stand center column (1) as
shown in drawing, making certain that holes
are aligned.
B. Insert and fasten the two long screws (4)
into the sides of the stand as shown.
C. Insert and fasten the two short screws (5)
and washers (10) into the rear of the stand
as shown.
D. Insert the spikes (6) or plastic floor levelers
(7), which are supplied in the parts bag, into
the holes located under the stand base.
E. If the floor leveler spikes (6) are used, also
mount the four washers (9), which are
supplied in parts bag, to fasten and lock
the spikes in position.
OTE: TO AVOID SPEAKER DAMAGE OR
POSSIBLE I JURY, USE THE SUPPLIED
HOOK & LOOP ADHESIVE STRIPS TO
SECURE YOUR SPEAKERS TO THE
SPEAKER STA D.
IMPORTA T: REMOVE THE SPEAKERS
FROM THE STA D PRIOR TO MOVI G THE
ASSEMBLED U IT. WHE I USE THESE
STA DS MUST BE PLACED O A FLAT A D
LEVEL SURFACE.
ote: One person can assemble this unit.
9
6
9
10
5
6
2
4
4
8
3
1
Allen Wrench
Plastic Levelers
Threaded Washer
Washer
Leveler Spikes
12mm Short Screw
18mm Long Screw
8
7
9
10
6
5
4