Belluscura X-PLO2R User manual

Removing Cartridge.
Cartridge Replacement
STEP 1
Turn off the X-PLO₂RTM by
pressing the power button
for 2 seconds.
Remove the battery
from the X-PLO₂R.
Pull the cartridge out
of the POC by pulling on the
cartridge pull handle.
Remove the X-PLO₂R
from the carrying bag,
if applicable.
Place the X-PLO₂R on
its side to access the underside
of the POC.
Remove the cartridge
completely from the X-PLO₂R
and throw away.
Turn sheet over to continue to step 2. LBL 5026-02
1
1
3
3
5
5
2
2
4
4
6
6
By:
1-877-774-9271 | www.oxygenconcentratorstore.com

Dust Cap
Installing Cartridge.
Cartridge Replacement
STEP 2
Remove cartridge from mylar bag.
The new cartridge has a dust cap on
top. Remove the dust cap. Make sure
there is no dust or debris where the
dust cap was located.
Push the cartridge into the
X-PLO₂R so it is fully inside.
Connect charged battery
to the X-PLO₂R.
Insert new cartridge top rst into the
X-PLO₂R. Do not leave the cartridge
ends exposed; the cartridge should be
inserted into the X-PLO₂R as soon as
the used cartridge is removed.
The cartridge pull handle
should lay at once the cartridge
is secured.
Turn on the X-PLO₂R by pressing the
power button for 2 seconds. Set the
ow setting to your prescribed setting
and use normally.
1
1
3
3
2
2
4
4
6
6
5
5
LBL 5026-02
By:
American Medical Sales and Rentals 15055 E. Hinsdale Drive, Bldg DCentennial, CO 80112 Phone: [phone] www.oxygenconcentratorstore.com E-mail: [email protected]