Belluscura X-PLO2R User manual

Placing X-PLO₂RTM in Backpack.
Backpack Instructions
STEP 1
Disconnect the cannula and remove
the X-PLO₂R from the
small carrying bag, if applicable.
Pull on ring to open the front pocket, so
you can place the X-PLO₂R inside.
(Be sure that the LCD screen is facing up, the
cannula connector is located on the right side, and
the intake vent aligns with the mesh panel.)
Continue threading the cannula down
through the backpack, toward the X-PLO₂R.
(Pull the cannula out through the grommet so it can
connect to the X-PLO₂R.)
Place backpack on a at
surface with the front pocket
and ring facing up.
Insert and thread the cannula
through the opening at the top
of the right shoulder strap.
Connect the cannula
to the X-PLO₂R.
Turn sheet over to continue to step 2.
1
1
3
3
5
5
2
2
4
4
6
6
LBL 5025-02
By:
1-877-774-9271 | www.oxygenconcentratorstore.com

Wearing the BackPack.
Backpack Instructions
STEP 2
American Medical Sales and Rentals 15055 E. Hinsdale Drive, Bldg DCentennial, CO 80112 Phone: [phone] www.oxygenconcentratorstore.com E-mail: [email protected]Place backpack on shoulders
and adjust the shoulder straps so
the backpack is comfortable.
Roll the cannula tubing to the desired
length. Secure the excess tubing inside
the backpack with the Velcro straps,
making sure not to kink the tubing.
Wrap the cannula up and over
both ears and insert the nasal
prongs into your nostrils.
(The cannula should t comfortably
around your head.)
Zip up the backpack and you’re
ready to go X-PLO₂R.
7
7
9
9
8
8
10
10
You can place additional batteries inside
the backpack if desired.
LBL 5025-02
By: