Belluscura X-PLOR Guide

CARTRIDGE REPLACEMENT


By:

Removing Cartridge.
Cartridge Replacement
PART 1


Turn off the X-PLOR®by
pressing the power button
for 2 seconds.
Remove the battery
from the X-PLOR.
Pull the cartridge out
of the POC by pulling on the
cartridge pull handle.
Remove the X-PLOR
from the carrying bag,
if applicable.
Place the X-PLOR on
its side to access the underside
of the POC.
Remove the cartridge
completely from the X-PLOR
and throw away.
Turn sheet over to continue to step 2.
11
33
55
22
44
66
By:

Dust Cap


Installing Cartridge.
Cartridge Replacement
PART 2


XPLOROxygen.com
Remove cartridge from mylar bag.
The new cartridge has a dust cap on
top. Remove the dust cap. Make sure
there is no dust or debris where the
dust cap was located.
Push the cartridge into the
X-PLOR so it is fully inside.
Connect charged battery
to the X-PLOR.
Insert new cartridge top first into the
X-PLOR. Do not leave the cartridge
ends exposed; the cartridge should be
inserted into the X-PLOR as soon as
the used cartridge is removed.
The cartridge pull handle
should lay flat once the cartridge
is secured.
Turn on the X-PLOR by pressing the
power button for 2 seconds. Set the
flow setting to your prescribed setting
and use normally.
11
33
22
44
6655
LBL 5026-03
By:
©2022 Belluscura LLC. All Rights Reserved.
Power Button