Belluscura X-PL02R User manual

Removing Cartridge.
Cartridge Replacement
STEP 1
Turn off the X-PLO₂RTM by
pressing the power button
for 2 seconds.
Remove the battery
from the X-PLO₂R.
Pull the cartridge out
of the POC by pulling on the
cartridge pull handle.
Remove the X-PLO₂R
from the carrying bag,
if applicable.
Place the X-PLO₂R on
its side to access the underside
of the POC.
Remove the cartridge
completely from the X-PLO₂R
and throw away.
Turn sheet over to continue to step 2.
11
33
55
22
44
66
By:

Dust Cap
Installing Cartridge.
Cartridge Replacement
STEP 2
Remove cartridge from mylar bag.
The new cartridge has a dust cap on
top. Remove the dust cap. Make sure
there is no dust or debris where the
dust cap was located.
Push the cartridge into the
X-PLO₂R so it is fully inside.
Connect charged battery
to the X-PLO₂R.
Insert new cartridge top rst into the
X-PLO₂R. Do not leave the cartridge
ends exposed; the cartridge should be
inserted into the X-PLO₂R as soon as
the used cartridge is removed.
The cartridge pull handle
should lay at once the cartridge
is secured.
Turn on the X-PLO₂R by pressing the
power button for 2 seconds. Set the
ow setting to your prescribed setting
and use normally.
11
33
22
44
6655
XplorOxygen.com
LBL 5026-03
By:
©2021 Belluscura LLC. All Rights Reserved.