BENSON OUH Series Quick start guide

WARNINGS
Installation of Benson Equipment must be carried out in accordance with the current IEE
wiring regulations (BS 7671), BS 6896 (Industrial & Commercial) and any other relevant
British Standards and Codes of Practice by a qualified installer. All external wiring MUST
comply with the current IEE wiring regulations.
WIRING DIAGRAM MANUAL FOR
BENSON OUH OIL FIRED HEATER

Wiring Diagrams - OUH Oil Fired Unit Heaters
Internal Wiring Diagram 33-65-100
OUHA 100-140 ON/OFF Riello Oil Fired Burner

Internal Wiring Diagram 33-65-106
OUHA 200-350 ON/OFF Riello Oil Fired Burner

Internal Wiring Diagram 33-65-107
OUHA 100-140 HI/LOW Riello Oil Fired Burner

Internal Wiring Diagram 33-65-108
OUHA 200-350 HI/LOW Riello Oil Fired Burner

Internal Wiring Diagram 33-65-191
OUHC 200-350 ON/OFF Riello Oil Fired Burner

Remote Connections 33-65-228
ON/OFF (HI/LOW) Less Controls
Remote Connections 33-65-131
ON/OFF (HI/LOW) to CP4

Remote Connections 33-65-130 HI/LOW to CP2OU
Remote Connections 33-65-102 ON/OFF to CP2OU

Remote Connections 33-65-229
HI/LOW to SmartCom SC3-MZ
Remote Connections 33-65-228
ON/OFF to SmartCom SC3-SZ

Benson Heating Ludlow Road Knighton
Powys LD7 1LP United Kingdom.
Telephone [phone]
Facsimile 01547 520399
Email [email protected]
Website www.bensonheating.co.uk
Benson Heating Ltd is a registered trademark of AmbiRad Limited. Because of continuous product
innovation, Benson Heating reserve the right to change product specification without due notice.