BEROTEC EC 250 User manual

GasGas / KTM / HUSQVARNA
CUMPAN
BEROTECBEROTEC
Benutzerhandbuch
User Guide
Manuel d‘utilisation
Manuale d‘uso
Manual del usuario
EC 250
EC 300
EX 250
EX 300
EXC 250-TPI
EXC 300-TPI
FE 250i
TE 300i
TX 300i
2-Takt / 2-stroke

4
BEROTEC
CUMPAN
Installation GasGas / KTM / HUSQVARNA
1. Install CUMPAN Display at desired position
» Look for the blue connector (1) above the cylinder.
» Insert intermediate plug (2) and connect with CUMPAN (black cable) (3)
» Lead cable behind the lamp mask
» Lay cables on the existing cable harness
3
2
Video
1
2. Connect RPM signal

5
English
4. Connect power
3. Engine temperature sensor (water temperature)
» Behind the lamp mask on the parking light removed
→brown = ground →green = plus
» Install on the water pump housing
» replaces the lower screw of the pump hou-
sing cover M6x20 screw
» Connect engine temperature sensor con-
nector
» Motor protection must not touch the
sensor
» Check the seal at operating temperature!
6. Settings in the „SENS“ menu: // SENSOR → UNI // COUNT → 18 // DAMPING → 200 //
7. Carry out calibration of the gears (see operating instructions)

[phone]
[e-mail]
www.berotec.de
BEROTEC GmbH
Georg-Schlatter-Straße 10
75031 Eppingen