
INFLATION
1. Before using the product, carefully check if there are any leaks
or broken parts.
Open valve and inflate with the air pump (not include) to
design working pressure on the product.
2. Fill the chambers until most of the wrinkles are gone and it
feels firm to touch but NOT hard. If you use other pressure
gauge, the pressure should not be more than the specified
pressure on the product or on the instruction. Do not
over-inflate the product. Do not use an air compressor.
3
Read the manual and follow the instructions relating to safety
tips, correct and complete product assembly, setting into service,
use and maintenance.
For your own safety, always heed the advice and warnings in
these instructions.
Non-compliance with these operating instructions may expose
you to serious danger. Only use the product in the places and
conditions for which it is intended.
• ATTENTION! NO PROTECTION AGAINST DROWNING!
• SWIMMERS ONLY!
• Full inflate all air chambers.
• Passenger numbers and load weight shall by no means exceed
passenger number and maximum weight capacity in
specifications.
• This product should not be used as life saving device.
• Life saving device (life jacket and life buoy) must be prepared
together and inspected.
• Keep away from flames and fires.
• Before every use, carefully inspect all product components, to
ensure everything is in good condition and tightly secured.
Please stop to repair if you find any damage.
• Be careful when landing on the ground. Sharp and rough
objects such as rocks, cement, shells, glass, etc. may
punctured the product.
• Don’t leave the product exposed to sun for long periods of time,
as high temperatures shall give rise to air expansion, which can
cause irreparable damage.
• Never leave in or near the water when not in use.
• Evenly distribute loads when use the product. Tipping and
drowning may occur with uneven distribution of loads.
TECHNICAL SAFETY INSTRUCTIONS
NOTE: While the pet is using the lounge, please pay attention to
minimize excessive movement in order to maintain the stability of
the lounge.
PRODUCT DESCRIPTION
NOTE: Drawing for illustration purpose only. May not reflect
actual product. Not to scale.
MAINTENANCE AND STORAGE
1. After deflation, use a damp cloth to gently clean all surfaces.
NOTE: Never use solvents or other chemicals that may
damage the product.
2. Store in a cool, dry place and out of children’s reach.
3. Check the product for damage at the beginning of each
season and at regular intervals when in use.
Please use this float by placing the side marked with a printed
warning up, while facing the other side toward the water.
WARNING
DEFLATION
REPACKING
a
e
d
a
c
b
a
c
ed
b
e
b
d
a(c)
1 2
3 4
5 6
87
Item No.
43553 A: 1.71 m x 94 cm x 16 cm
B: 71.5 cm x 62.5 cm x 11 cm A: 130 kg
B: 10 kg(Only for pet using)
Inflated Size Maximum Load Capacity
A
B
NOTE: Under and over-inflation of the product will result in
safety hazards. It is better to check the pressure of the product
each time before using.
3. Be sure to close the valves after inflation, press in the safety
valves after inflation.
NOTE: Never stand on or rest objects on the product during
inflation. Always check product for leaks before use.