
When installing and using this electrical equipment, basic safety precautions should always be followed,
including the following:
(1) READ AND FOLLOW ALL INSTRUCTIONS.
(2) Ensure that children do not attempt to access cleaner while it is operating.
(3) The cleaner must only be supplied at safety extra-low voltage in accordance to the marking applied
on it.
(4) If an USB charging adaptor (not included) is used, make sure to connect it to the power source
through a residual current device (RCD) / a ground fault circuit interrupter (GFCI). If in doubt, consult
a qualified, professional electrician.
(5) The cleaner is designed to clean the swimming pool, SPA.
(6) Please use the original batteries and USB Line when using.
(7) Only charging it when the cleaner is power off.
(8) Put the cleaner into a clean and dry place. Do not expose it under the sun, or close to explosive.
(9) The filter bag is easy to be broken when there is sharp substances under water.
(10) The cleaner automatically stops to work when it is out of water.
(11) Do not close to the vacuum head when it is working, due to its suction power, especially for the
human body, animals, hairs or clothes.
(12) Do not leak the lubricant oil, and it causes water polluted.
(13) Cleaner working conditions:
(13-1) Water depth from 50cm to 256cm
(13-2) Water temperature: 4°C(39.2°F)-35°C(95°F)
(14) SAVE THESE INSTRUCTIONS
Above warning and cautions are not intended to incorporate all possible instances for
risks and/or severe injury. Pool/spa owners should always exercise intensive caution and
common sense when operating the cleaner.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
2
OWNER’S MANUAL
Model No.58649E
SAFETY WARNING
OPERATING WARNING
PARTS LIST
1
2
34
5
6
7
NOTE: When fully charged, the charging indicator will show a green light.
NOTE: Charge the cleaner 5-6 hours prior to the first use.Normally cleaner can be operated about
50 minutes after fully charged.