Better Homes and Gardens Bryant Series User manual

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Date 2018-04-27 Rev. 0001-A Factory: CTHAUP
Bryant Dining Table
Stock # BH16-084-299-01
# BH18-084-097-46
ADULT ASSEMBLY REQUIRED
If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the
store where it was purchased. Please call our customer service number and have your instructions
and parts list ready to provide the model name, part name or factory number:
866-942-5362
Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday - Friday
Or visit our web site 24 hours a day, 7 days a week for product assistance at
www.whalenstyle.com
Or e-mail your request to [e-mail]
LOT NUMBER:
DATE PURCHASED: / /

2
1. Maximum load weight on table is 400 pounds (181.4 kg).
1. Please read the Assembly Instructions prior to assembling the unit.
2. To avoid damage, assemble the unit on a sturdy, level and non-abrasive surface.
3. Keep all hardware and part out of reach of children.
4. Please wait until all steps are completed before tightening bolts.
5. Make sure all bolts and screws are tightly fastened before the unit is used.
GENERAL INFORMATION, TIPS
and
TRICKS
MAXIMUM RECOMMENDED WEIGHT LOADS
THIS UNIT IS INTENDED ONLY FOR USE WITHIN THE
MAXIMUM WEIGHTS INDICATED. USE WITH LOADS HEAVIER THAN THE
MAXIMUM WEIGHTS INDICATED MAY RESULT IN INSTABILITY CAUSING
POSSIBLE INJURY.

3
Parts and Hardware List
Please read completely through the instructions and verify that all listed parts and hardware are present
before beginning assembly.
A- Table Top (Qty. 1)
B- Leg (Qty. 4)
(1) 5/16” x 3-1/2” Bolt (Qty. 8+1 extra) (2) Lock Washer (Qty. 8+1 extra)
(3) Flat Washer (Qty. 8+1 extra) Open Wrench (Qty. 1)
Tools required:
Open wrench (provided).

4
Assembly Instructions
1. Unpack the unit and confirm that you have all the hardware and required parts. Assembly the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Position the Table Top (A) upside down on a level and protective surface, as shown.
3. Attach four Legs (B) to the corners of Table Top (A) by using eight 3-1/2” Bolts (1) with Lock Washers
(2) and Flat Washers (3) through the corner blocks and screw into the threaded inserts in the Legs.
Securely tighten the bolts with the provided open wrench.
DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.
Flat Washer
(8 used in this step)
③
Lock Washer
(8 used in this step)
②
3-1/2” Bolt (8 used in this step)
①
A
B
B
B
B
B
A
23
1

5
Assembly Instructions
4. Ask for assistance to lift the unit upright and position it at the desired location.
5. If necessary, adjust the pre-attached floor levelers at the bottom of Legs (B) to level the unit.
B
B
B
B
A
B