Quinta MU 22
DESCRIPTION
The Quinta MU 22 delegate microphone unit is equipped with two
microphone buttons in the housing so that two participants can
share one microphone unit. The operating software can differentiate
who is to speak.
With the Automatic Channel Allocation function the transmitting
channels of the microphone units are allocated automatically. When
the microphone button is pressed in the manual operating mode
the request-to-talk is received by the control unit (a possible
external dual colour LED will illuminate red). Then the control unit
checks which of the available receiving channels is free. Then the
control unit informs the microphone unit which channel it should
use for transmitting. When the channel of the microphone unit is set
and checked by the control unit, the microphone is switched on.
The ready-to-talk status of the microphone is also indicated by the
red LED ring around the gooseneck microphone. In the Request-
to-Talk-mode of the discussion system the request-to-talk is
received, but the microphone is not switched on. The red LED
indicates that the request-to-talk has been received. The micro-
phone is switched on by the operator at the PC by using the
“Quinta Conference” software or a media control system. When
the microphone button is pressed once again, the delegate clears
his/her request-to-talk.
Depending on the configuration with the “Quinta Conference”
software the following operating modes are available:
Override: the first microphone is switched off, when the maximum
number of switched on microphones is exceeded.
Voice activation: the microphone is switched on, when someone
speaks into it.
Push-To-Talk: the microphone button is held down, while the
participant is speaking.
The integrated loudspeaker reproduces the audio signal of the
whole conference system. Depending on the audio signal routing in
the control unit the loudspeaker can reproduce other audio signals
such as a wireless microphone in the auditorium.
The parameters of the microphone unit are adjusted via PC by using
the “Quinta Conference” software. The parameters are adjusted
for all microphone units.
A headphone (e.g. DT 1) can be connected to the documentation
output. The volume of the loudspeaker is adjusted and can be
controlled with the Quinta CU control unit or a media control system.
The ducking level determines the attenuation of the loudspeaker
level when the microphone of the microphone unit is switched on.
Each microphone unit has its own address. An existing system can
be complemented at any time.
The DSSS transmission offers high immunity against unauthorised
listening with a 128-bit encryption. In addition to this, the conference
system including the appropriate microphone units can be protected
with PIN code (24-bit). A microphone unit that does not have the
correct PIN code will be identified by the control unit and switched
off immediately.
The integrated rechargeable battery allows a minimum operation
of the microphone unit of 20 hours depending on the participation
in the discussion. As soon as the remaining battery time is below a
certain threshold of 1 hour, the power on LED on the rear of the
microphone unit will flash or if the system is controlled by PC or a
media control system, the low battery capacity can be also
indicated. The charging time of a completely empty battery is
around 2.5 hours with the integrated processor-controlled charging
electronics. Depending on the use of the microphone unit the
charging time can be less.
As an option the microphone unit can be powered and charged by
a DC power supply adapter.
The microphone unit is switched on by briefly pressing the micro-
phone button once. There are various ways to switch off the
microphone unit:
1. Press the microphone button for 3 seconds.
2. Press the standby button of the MCW-D 50 control unit for
3 seconds to switch off all activated microphone units.
3. Switch off all microphone units via an RS 232 or TCP/IP
command from the PC or media control system.
4. Switch off the control unit; after approx. 3 minutes the micro-
phone unit will be switched off.
beyerdynamic GmbH & Co. KG
Theresienstr. 8 | 74072 Heilbronn – Germany
Tel. +49 (0) 71 31 / 617 - 0 | Fax +49 (0) 71 31 / 617 - 204
For further distributors worldwide, please go to www.beyerdynamic.com
Non-contractual illustrations. Contents subject to change without notice. E1 / Quinta MU 22 (07.12)
2 of 7
OPTIONAL ACCESSORIES
GM 313 Q Condenser (electret) gooseneck
microphone cardioid, matt black,
300 mm long. . . . . . . . . . . . . . . . . Order # 724.203
GM 314 Q same as above, but 400 mm long . . Order # 724.211
GM 315 Q same as above, but 500 mm long . . Order # 724.238
GM 316 Q same as above, but 600 mm long . . Order # 724.351
CC2 Modular charging and transport case
for 10 Quinta microphone units. . . Order # 723.967
CC2/600 Charging and transport case for 10
Quinta microphone units with
GM 316 Q gooseneck microphone . Order # 724.572
CD 2 Modular charging and transport unit
for 10 Quinta microphone units
with GM 313, 314 or 315
gooseneck microphone . . . . . . . . . Order # 723.975