Bilstein Blue Print ADC44288 User manual

www.blue-print.comwww.blue-print.com
EN
Ferdinand Bilstein GmbH + Co. KG
Wilhelmstr. 47 | 58256 Ennepetal | Germany | Tel. [phone] | www.bilsteingroup.com
Technical data can be subject to change PROTIPS
Problem
When replacing the rear brake pads and/or the rear brake discs, the vehicle is required to be set into
maintenance mode. By doing this, the EPB motor gear unit will operate and allow the brake pistons to be
pressed in for brake maintenance purposes.
Cause
When the EPB is applied, the EPB system detects the current brake disc posion and automacally
adjusts it to the opmum EPB release posion (brake pad to disc clearance).
Failure to carry out the correct procedure (i.e. inially seng the vehicle into maintenance mode) will
potenally cause an operaonal problem with the EPB system.
Soluon
When performing repairs and maintenance to the rear brakes on the vehicles listed above, it is important
to set the vehicle into maintenance mode as explained on the following page.
Cauon: If performing this procedure while the vehicle is on the ground, block the front and rear wheels
using wheel blocks. Failure to do this may result in the vehicle moving when the electric parking brake is
released.
The EPB system will not work if the baery voltage is insucient. Therefore, it is advised to use a baery
support unit while carrying out this operaon.
For more technical informaon please visit: partsnder.bilsteingroup.com
Blue Print
ADC44288, ADM542112,
ADM542114, ADM543124,
ADM543127
To t:
Mazda 6, Mazda CX-5 equipped with electronic parking brake (EPB)
Rear brake pads, Rear brake discs

www.blue-print.comwww.blue-print.com
EN
Ferdinand Bilstein GmbH + Co. KG
Wilhelmstr. 47 | 58256 Ennepetal | Germany | Tel. [phone] | www.bilsteingroup.com
Technical data can be subject to change PROTIPS
For more technical informaon please visit: partsnder.bilsteingroup.com
Blue Print
ADC44288, ADM542112,
ADM542114, ADM543124,
ADM543127
To t:
Mazda 6, Mazda CX-5 equipped with electronic parking brake (EPB)
Seng to maintenance mode.
1. Switch the ignion ON (engine o).
2. Release the electric parking brake.
3. Switch the ignion o, and then switch the ignion ON (engine o) within 5 seconds while
maintaining the following condions.
• Press the electric parking brake switch.
• Depress the accelerator pedal fully.
4. Verify that the electric parking brake warning light is illuminated in an amber colour and the mode is
switched to maintenance mode.
5. Switch the ignion o.
Carry out all necessary repairs or replacement of the rear brakes.
Ending maintenance mode
1. Switch the ignion ON (engine o).
2. Switch the ignion o, and then switch the ignion ON (engine o) within 5 seconds while
maintaining the following condions.
• Pull-up the electric parking brake switch.
• Depress the accelerator pedal fully.
3. Verify that the electric parking brake warning light turns o and the maintenance mode is ended.
4. Switch the ignion o.
Aer all repairs have been completed, check the EPB operaon when the engine is running or with a fully
charged baery (engine o).