Bilstein E4-WM5-Y267A00 User guide

E4-WM5-Y267A00
EINBAUANLEITUNG/ MOUNTING INSTRUCTION
erstellt am: 31.07.200 E4-WM5-Y267A00_0 Seite 1 zuletzt geändert am:

E4-WM5-Y267A00
EINBAUANLEITUNG/ MOUNTING INSTRUCTION
erstellt am: 31.07.200 E4-WM5-Y267A00_0 Seite 2 zuletzt geändert am:
FORD Mustang front strut V36-4138
Installation instructions
1. Remove OE strut from vehicle, referring to manufacturer’s Service Manual.
2. Discard original jounce bumper (10) located on OE strut piston rod or inside OE dust cover (9). The Bilstein
strut has a built-in jounce bumper.
3. Decide whether to re-use OE dust cover, or Bilstein replacement dust cover (12). (The Bilstein strut is de-
signed to function properly with either dust cover.)
·If Bilstein dust cover (12) will be used, remove the metal clamp (8) from the top of the OE dust cover (9),
and pull the dust cover downwards off of the lower isolator (7). Discard the clamp and dust cover.
·If original dust cover will be used, pull the Bilstein dust cover (12) upwards off the Bilstein strut, and dis-
card.
4. Assemble the upper mounting parts to the Bilstein strut as follows:
·Lower isolator (7) (with OE dust cover, if re-used).
·Mount plate (6)
·Upper rubber isolator (4)
·Steel sleeve (3)
·Upper retainer plate (2)
·Bilstein top nut (11); tighten to 75 – 110 Nm (55 – 80 lb/ft) (discard original top nut (1))
5. Mount Bilstein strut into vehicle, referring to instructions in vehicle manufacturer’s Service Manual.
6. Set front wheel alignment to OE specifications
Krupp Bilstein Suspension GmbH
August-Bilstein-Str. 4, 58256 Ennepetal
Postfach 11 51, 58240 Ennepetal
Telefon: [phone], Telefax: (0 23 33) 7 91- 45 80
Internet: www.bilstein.de