bioBidet Discovery DLS User manual

OPEN/CLOSE LID OPEN/CLOSE SEAT NIGHT LIGHT
Open or close the lid. Open or close the seat. Turns the night light on/off.
FRONT REAR STOP
Activate oscillating front wash. Activate oscillating rear wash. Stop any operation.
Press again to turn off oscillation. Press again to turn off oscillation.
DRY AUTO
Press to activate the warm air dryer. Activates a rear wash for 90 seconds,
Press again to adjust the fan speed. followed by the dryer for 4 minutes.
Low - Blue | Medium - Purple | High - Red Press again to skip to dryer function.
The dryer automatically turns off after 4 minutes.
DYNAMIC STREAM NOZZLE CLEAN
Activate during a wash to quickly alternate Extends the nozzle for manual cleaning.
the water temperature from warm to cold. The seat must be unoccupied.
WATER TEMPERATURE | AIR TEMPERATURE | SEAT TEMPERATURE
Press the corresponding button to adjust the temperature settings.
Low - Blue | Medium - Purple | High - Red
WATER PRESSURE
Press the + or - buttons to adjust the water pressure accordingly.
NOZZLE POSITION
Press the arrow keys to adjust the position of the nozzle accordingly.
PHONE: [phone] | EMAIL: [e-mail]|CHAT: WWW.BIOBIDET.COM
FUNCTIONS
SETTINGS
REMOTE
QUICK GUIDE
Support: 847.458.2334
Dynamic
stream
Nozzle
forward
Nozzle
backward
Water
pressure
Water
pressure
Nozzle
clean
Night
light
Air
temp
Water
temp
Seat
temp
Open/Close
seat
Open/Close
lid

Our goal is to provide you with the highest quality products and service possible.
If there is anything we can do to assist with your purchase, we have trained customer service professionals
waiting to assist you. Please feel free to connect with us via phone, email, or chat.
REMOTE
Remove the existing toilet seat
and insert the rubber anchors
into the mounting holes.
Attaching the rubber anchors Connecting the water hose
Place the catch plate and guides
over the mounting holes. Insert the
mounting screw and secure the
catch plate to the toilet.
Attaching the mounting plate
rubber anchors
mounting holes
mounting plate mounting bolt guide
rubber anchor
Attaching the bidet seat
Slide the bidet seat all the
way on to the catch plate.
release button
Seat sensor
This appliance is equipped with
a seat sensor aand will not
function unless occupied.
seat sensor
water supply
hose (7/8”)
bidet supply
hose (1/2”)
t-valve
water tank
shutoff valve
bidet seat
Close the water shutoff valve.
Flush the toilet to empty the tank.
Remove the existing water supply hose from the
tank.
Install the t-valve on to the tank.
Connect the 7/8” water supply hose to the water
shutoff valve and t-valve.
Connect the 1/2” water supply hose to the bidet
seat and t-valve.
Open the water shutoff valve.
Check for any leaking or dripping.
Water Does it Better ®
PHONE: [phone] | EMAIL: [e-mail]|CHAT: WWW.BIOBIDET.COM
QUICK GUIDE
QUICK INSTALLATION GUIDE
CONGRATULATIONS ON YOUR PURCHASE