Bionaire BT16RBS-IN User manual

TOWER FAN
pure indoor living
MODEL# BT16RBS-IN
INSTRUCTION MANUAL
Read instructions before operating. Retain for future reference.
LEARNING MORE
For a wealth of information about your fan and other Bionaire®products, visit our web-
site at www.bio aire.com.
THIS PRODUCT IS MANUFACTURED TO COMP Y WITH THE E.E.C.
DIRECTIVES 2006/95/EC AND 2004/108/EC.
Waste electrical products should not be disposed of with house-
hold waste. Please recycle where facilities exist. Check on the
following website for further recycling and WEEE information:
www.bionaire.com.
Please see warranty card for warranty information.
© 2010 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights
reserved. Manufactured by Sunbeam Products, Inc. doing business as Jarden Consumer
Solutions, 2381 Executive Center Drive, Boca Raton, Florida 33431 U.S.A. Distributed by
Jarden Consumer Solutions of India Private imited, Unit Number B-204, Universal Busi-
ness Park Off Saki Vihar Road, Chandivli Farm Road Andheri (E), Mumbai 400-072,
India. Telephone : [phone]
Printed in PRC
123357-000-000
SPR-012210
CLEANING
1. Switch off and unplug the power cord be-
fore assembling or disassembling and
cleaning.
2. Clean the fan with a soft cloth moistened
with a mild soap solution.
3. Do not allow water to drip on or into the
fan motor housing.
CAUTION: Do not use harsh deter-
gents, chemical cleaners, gasoline or
solvents as they may damage the sur-
face finish of the lastic com onents.
Also, do not immerse in liquids.
NOTE: Unit must be un lugged for
it to be fully off.

BT16RBS-IN
Fig. 1
Fig. 3
Fig. 4
PLEASE READ AND SAVE THESE
IMPORTANT INSTRUCTIONS
1. Read all instructions before using this
appliance.
2. To avoid fire or shock hazard, plug the
appliance directly into an appropriate
electrical outlet.
3. Keep the power cord out of heavy traffic
areas. To avoid fire hazard, NEVER put
the power cord under rugs, near heat
registers, radiators, stoves, or heaters.
4. To protect against electrical hazards, DO
NOT immerse the appliance in water or
other liquids. Do not use near water.
5. NEVER drop or insert any objects into
the openings of the unit.
6.
Do not operate any appliance with a
damaged power cord or plug. If the motor
fails to operate or the unit has been
dropped or damaged in any manner,
return appliance to manufacturer for
examination and/or repair.
7. DO NOT use outdoors.
8. NEVER place on a soft surface such as
a bed or sofa as this could cause the unit
to tip over and block the air inlet or outlet
grills.
9. DO NOT place anything on top of unit.
10. WARNING: To reduce the risk of fire or
electric shock, DO NOT use this
appliance with any solid-state speed
control device.
11. CAUTION: In order to avoid a hazard
due to inadvertent resetting of the
thermal cutout, this appliance must not
be supplied through an external
switching device, such as a timer, or
connected to a circuit that is regularly
switched on and off by the utility.
12. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety. Children should be
supervised to ensure that they do not
play with the appliance.
13. This product is not desgned or intended
to be used with an extension cord.
ASSEMBLY INSTRUCTIONS
1. Assemble Base Halves (E) around the
cord. Refer to FIGURE 5.
2. Secure assembled base to the Fan
Housing with two thumb screws (F).
Refer to FIGURE 5
3. Secure Power Cord (G) as shown in
FIGURE 6
4. Secure the Wiring Clip Slot (H) with the
remaining two Philips head screws.
Refer to FIGURE 6
OPERATING INSTRUCTIONS
(S Fig. 2, 3, 4)
Remote Control: Remote Control requires
2 AAA batteries for operation. There is a
slot on the back of the unit (Refer to Fig.
2) to store the remote when not using.
A. Power/Speed Settings
Press = On, I,
II, III, Off
B. Timer Control
Press = Turns Off in 1, 2, 4, 8 hours
C. Oscillation Control
Press = Oscillation On, Off
D. Natural Breeze, Sleep Breeze Modes
Press = Natural
Breeze, Sleep Breeze
Natural Breeze Mode will randomly
cycle through the fan speed settings
from High, Medium, ow & OFF to
simulate a natural breeze until the user
turns the unit OFF.
Sleep Breeze Mode will
automatically cycle from the selected
speed setting to ow until user turns
the unit OFF.
ENGLISH
Fig. 2
A
A. Power/Speed
Co trol
B. Timer Co trol
C. Oscillatio Butto
D. Natural Breeze a d
Sleep Breeze Modes
E. Base Halves (2)
F. Thumb Screws (2)
G. Power Cord
H. Wiri g Clip Slot
B
C
D
A
B
C
D
Fig. 5
E
F
Fig. 6
GG