Bioness NESS L300 Product information sheet

Manufactured by:
Bioness Neuromodulation Ltd.
A Bioness Inc Company
19 Ha’Haroshet Street
PO Box 2500
Industrial Zone
Ra’Anana 43654, Israel
User’s Reference Card
While seated, slightly extend your lower leg.
2. Tilt the top of the L300 FS Cuff toward you, and then slide it up your leg until the locator
rests below the kneecap. Lower the bottom of the L300 FS Cuff onto your leg.
3. Hold the L300 FS Cuff in place with your thumb or other hand on the RF Stim Unit cradle.
Pull the strap handle around the cradle.
4. Figure 4 shows the L300 FS Cuff correctly placed on the right leg. (Regular L300 FS Cuff shown.)
1
2
3
4
4321
Press the on/off button to turn on the Control Unit.
Select either gait or training mode:
• To select gait mode, press the mode button briefly.
• To select training mode, press and hold the mode button until (“t” for training)
appears in the digital display.
If necessary, adjust the stimulation intensity level by pressing the plus or minus
button.
1
2
3
Putting On the L300 Functional Stimulation (FS) Cuff
NESS®, NESS L300®, Intelli-Gait®, Intelli-Sense Gait Sensor™, Bioness, the Bioness Logo® and LiveOn® are trademarks of Bioness Inc. | www.bioness.com
European Authorized Representative
Ness Europe B.V.
Stationsweg 41
3331 LR Zwijndrecht, The Netherlands
Telephone: [phone]
Email: [email protected]
Website: www.bioness.com
Worldwide Corporate Office
Bioness Inc
25103 Rye Canyon Loop
Valencia, CA 91355
Telephone: [phone]
Email: [email protected]
Website: www.bioness.com
Operating the NESS L300 System
On/Off Button
Mode
Button
Plus/Minus
Intensity
Adjustment
Buttons Digital
Display
Volume Adjustment Buttons
Control Unit
Indicator
Intelli-Sense
Gait Sensor™
Indicator
RF Stim Unit
Indicator
612-00096-001 Rev. B
FOR REFERENCE ONLY

Connect the system charger set to the RF Stim Unit and Control Unit, then plug into a wall
socket. (Regular L300 FS Cuff shown.)
Flashes Green System is On
Flashes Yellow SLOWLY System is in Gait/Training/Clinician
Mode, Stimulation is Off
Flashes Yellow RAPIDLY System is in Gait/Training/Clinician
Mode, Stimulation is On
Displays 0–9 Intensity Level
Alternately Displays Intensity
Level and “t” Training Mode is On
Flashes Green System is On
Flashes Yellow SLOWLY Stimulation is Off
Flashes Yellow RAPIDLY Stimulation is On
Flashing
Faulty Electrode Contact
Gait Sensor Hibernation or Radio
Communication Failure between the Gait
Sensor and RF Stim Unit
Flashing
Radio Communication Failure Between the
Control Unit and RF Stim Unit
A Component Indicator is Solid Red:
Component Malfunction
Flashing Solid RF Stim Unit Malfunction Only
Charging the Batteries
A Component Indicator
Flashes Yellow Component Low Battery
Rotating Circle Control Unit Charging
Horizontal Line Control Unit Fully Charged
Flashes Yellow Low Battery
Alternately Flashes Yellow
and Green Charging
Solid Green Fully Charged
Control Unit Displays
RF Stim Unit Displays
System Error Displays
See User’s Guide Rx Only (US only)
FOR REFERENCE ONLY