Birlea POPPY 3’ BED User manual

Vendor: S000053
Page 1 of 3
ASSEMBLY INSTRUCTIONS
POPPY 3’ BED
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE OR
USE YOUR POPPY 3’ BED FRAME
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
HEALTH & SAFETY:
DO NOT jump on this bed frame
DO NOT use this bed frame if any parts are missing, damaged or worn
DO NOT use this bed frame unless all fixings are secured
Always use on a level, even surface
WARNING: If this ed is placed on a laminated floor you must place some protection under all legs
to stop the ed frame from moving. If this is not adhered to there is no guarantee if the ed frame
collapses
CARE & MAINTENANCE:
Periodically chec all screws & fixings to ensure they are secure
DO NOT push the bed frame as this will damage the legs
Always lift the bed with two people to reposition
Keep any sharp objects away from the frame
www.birlea.com

Vendor: S000053
Page 2 of 3
Parts List Hardware List
Part Description Qty Part Description Qty
1 Headend 1 A M6 x 16 mm JCBC Screw 8
2 Footend 1 B M6 x 45 mm JCBC Screw 2
3 Side Support 2 C M6 Nut 2
4 Mid Support 1 D Slat Cap 24
5 Slat 12 ** M4 Allen Key provided
Step 1: Fix the side support (3) to the headend (1) and footend (2) using hardware part A but do not fully
tighten yet
DO NOT use any power tools as this may damage the frame and will invalidate any claim
Step 2: Place the mid support (4) on top of the side supports (3) and tightly secure using hardware parts B
and C
DO NOT use any power tools as this may damage the frame and will invalidate any claim

Vendor: S000053
Page 3 of 3
Step 3: Slot hardware part D onto every end of each slat (5), then press firmly into the side supports (3)
DO NOT use any power tools as this may damage the frame and will invalidate any claim.
For complete product information, images and dimension diagrams please
visit www.birlea.com