Black & Decker BDC2A User manual

www.blackanddecker.com.au
www.blackanddecker.co.nz
1
2
BDC2A

2
ENGLISH (Original instructions)
Intended use
Your BLACK+DECKER BDC2A charger has been designed
for charging BLACK+DECKER 18V Li-Ion and 54V
DUALVOLT Li-Ion battery packs. This appliance is intended
for consumer use only.
Safety instructions
General safety warnings
Warning! Read all safety
warnings and all instructions.
Failure to follow the warnings
and instructions listed below
may result in electric shock, re
and/or serious injury.
Warning! When using battery
powered appliances, basic
safety precautions, including
the following, should always be
followed to reduce the risk of
re, leaking batteries, personal
injury and material damage.
Separate collection of used products and
packaging allows materials to be recycled
and used again. Re-use of recycled
materials helps prevent environmental
pollution and reduces the demand for raw
materials.
uRead all of this manual carefully before
operating the appliance.
uThe intended use is described in this
manual. The use of any accessory
or attachment or the performance
of any operation with this appliance
other than those recommended in this
instruction manual may present a risk
of personal injury.
uRetain this manual for future
reference.
Using your appliance
uAlways take care when using the
appliance.
uThis appliance can be used by children
aged from 8 years and above and
persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge
if they have been given supervision
or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
uCleaning and user maintenance shall
not be made by children without
supervision.
uThe appliance is not to be used as a
toy.
uUse in a dry location only. do not allow
the appliance to become wet.
uDo not immerse the appliance in water.
uDo not open body casing. There are
no user serviceable parts inside.
uDo not operate the appliance in
explosive atmospheres, such as in the
presence of ammable liquids, gases
or dust.
uTo reduce the risk of damage to plugs
and cords never pull the cable to
remove the plug from a socket outlet.
After use
uWhen not in use, the appliance should
be stored in a dry, well ventilated place
out of reach of children.
uChildren should not have access to
stored appliances.

3
ENGLISH
(Original instructions)
uWhen the appliance is stored or
transported in a vehicle it should be
placed in the boot or restrained to
prevent movement following sudden
changes in speed or direction.
Inspection and repairs
uBefore use, check the appliance
for damaged or defective parts.
Check for breakage of parts and any
other conditions that may affect its
operation.
uDo not use the appliance if any part is
damaged or defective.
uHave any damaged or defective parts
repaired or replaced by an authorised
repair agent.
uNever attempt to remove or replace
any parts other than those specied in
this manual.
Power cord safety
uWarning!Never alter the ac power
cord or plug. If it will not t, have a
proper outlet installed by a qualied
electrician. Improper connection may
result in an electric shock.
Additional safety instructions for
batteries and chargers
Batteries
uNever attempt to open for any reason.
uDo not expose the battery to water.
uDo not store in locations where the
temperature may exceed 40 °C.
uCharge only at ambient temperatures
between 10 °C and 40 °C.
uCharge only using the charger
provided with the appliance/tool. Using
the wrong charger could result in an
electric shock or overheating of the
battery.
uWhen disposing of batteries, follow the
instructions given in the section
“Protecting the environment”.
uDo not damage/deform the battery
pack either by puncture or impact, as
this may create a risk of injury and re.
uDo not charge damaged batteries.
uUnder extreme conditions, battery
leakage may occur. When you notice
liquid on the batteries carefully wipe
the liquid off using a cloth. Avoid skin
contact.
uIn case of skin or eye contact, follow
the instructions below.
Warning! The battery uid may cause
personal injury or damage to property. In
case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention
Chargers
Your charger has been designed for a
specic voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
uUse your BLACK+DECKER charger
only to charge the battery in the
appliance/tool with which it was
supplied. Other batteries could burst,
causing personal injury and damage.
uNever attempt to charge non-
rechargeable batteries.
uIf the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
uDo not expose the charger to water.
uDo not open the charger.
uDo not probe the charger.

4
ENGLISH (Original instructions)
uThe charger must be placed in a well
ventilated area when charging.
Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc. Even with the application of
the relevant safety regulations and the
implementation of safety devices, certain
residual risks can not be avoided. These
include:
uInjuries caused by touching any
rotating/moving parts.
uInjuries caused when changing any
parts, blades or accessories.
uInjuries caused by prolonged use of a
tool. When using any tool for
prolonged periods ensure you take
regular breaks.
uImpairment of hearing.
uHealth hazards caused by breathing
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
Symbols on the charger
The following symbols are shown on the
appliance along with the date code:
Warning! To reduce the risk of
injury, the user must read the
instruction manual.
Do not attempt to charge dam-
aged batteries.
The charger is intended for
indoor use only.
Electrical safety
#Your charger is double insu-
lated; therefore no earth wire is
required. Always check that the
mains voltage corresponds to the
voltage on the rating plate. Never
attempt to replace the charger
unit with a regular mains plug.
uIf the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features.
1. Charger
2. Charging indicator
Assembly
Warning! Before assembly, remove the battery from the
appliance/tool.
Fitting and removing the battery
uTo t the battery, line it up with the receptacle on the tool.
Slide the battery into the receptacle and push until the
battery snaps into place.
uTo remove the battery, push the battery release button
while at the same time pulling the battery out of the
receptacle.
Use
Warning! Let the tool work at its own pace. Do not overload.
Charging the battery
The battery needs to be charged before rst use and
whenever it fails to produce sufcient power on jobs that were
easily done before. The battery may become warm while
charging; this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10°C or above 40 °C.
The battery should be left in the charger and the
charger will begin to charge automatically when the cell
temperature warms up or cools down.
uTo charge the battery, insert it into the charger (1). The
battery will only t into the charger in one way. Do not
force. Be sure that the battery is fully seated in the
charger.
uPlug in the charger and switch on at the mains.
The charging indicator (2) will blink.
The charge is complete when the charging indicator (2)
switches to continuously on. The charger and the battery can
be left connected indenitely.
The LED will switch on as the charger occasionally
tops up the battery charge.

5
ENGLISH (Original instructions)
uCharge discharged batteries within 1 week.
Battery life will be greatly diminished if stored in a
discharged state.
Leaving the battery in the charger
The charger and battery pack can be left connected with the
LED glowing indenitely. The charger will keep the battery
pack fresh and fully charged.
Maintenance
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning! Before performing any maintenance on the tool,
remove the battery from the tool. Unplug the charger before
cleaning it.
uRegularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
uRegularly clean the motor housing using a
damp cloth.
uDo not use any abrasive or solvent-based cleaner.
Protecting the environment
ZSeparate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be
recovered or recycled, reducing demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
BDC2A
Input Voltage
VAC 230
Output Voltage
VDC 18
Current
A2
Approx. charge time mins 45 -120
Australia & New Zealand
StStanley Black & Decker
www.blackanddecker.com.au
www.blackanddecker.co.nz
Tel.[phone] (Aust) or Tel. [phone] (NZ)

N524905 03/2017