Black & Decker BDSL301 User manual

BDSL302
BDSL301
UK
Ireland
Australia
New Zealand

2

3
Intended use
Your Black & Decker spotlight has been designed for
providing illumination for home and leisure use. This product
is intended for consumer use only.
Safety instructions
Warning! When using battery-powered appliances, basic
safety precautions, including the following, should always be
followed to reduce the risk of fire, leaking batteries, personal
injury and material damage.
XRead all of this manual carefully before using the
appliance.
XThe intended use is described in this manual. The use
of any accessory or attachment or the performance of
any operation with this appliance other than those
recommended in this instruction manual may present a
risk of personal injury.
XRetain this manual for future reference.
Using your appliance
Always take care when using the appliance.
XThis appliance is not intended for use by young or infirm
persons without supervision.
XThe appliance is not to be used as a toy.
XUse in a dry location only. Do not allow the unit to
become wet.
XDo not immerse the appliance in water.
XDo not open body casing. There are no user-
serviceable parts inside.
XDo not operate the appliance in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust.
XTo reduce the risk of damage to plugs and cords never
pull the cable to remove the plug from a socket outlet.
After use
XWhen not in use, the appliance should be stored in a
dry, well ventilated place out of the reach of children.
XChildren should not have access to stored appliances.
XWhen the appliance is stored or transported in a vehicle
it should be placed in the boot or restrained to prevent
movement following sudden changes in speed or
direction.
XThe appliance should be protected from direct sunlight,
heat and moisture.
Inspection and repairs
XBefore use, check the appliance for damaged or
defective parts. Check for breakage of parts, damage to
switches and any other conditions that may affect its
operation.
XDo not use the appliance if any part is damaged or
defective.
XHave any damaged or defective parts repaired or
replaced by an authorised repair agent.
XNever attempt to remove or replace any parts other than
those specified in this manual.
Specific safety instructions for spotlights
The following safety symbols are marked on your spotlight:
XAllow the spotlight to fully cool down before storage or
charging.
XKeep combustible materials away from spotlight lens.
Extreme heat can cause fires.
XNever place the light face-down on any surface when it
is switched on or cooling.
XDo not leave the spotlight unattended. Keep children
and animals away from the work area.
XInspect the lens for damage following impact or if the
spotlight is dropped. Do not operate without the lens in
place or with a damaged lens.
XThe lens is manufactured from glass. The lens may
crack or break if subject to an impact. If the lens is
damaged it must be replaced by manufacturers original
parts. Wear gloves as sharp edges may cause injury.
XNever look directly into the light or shine the light into
another person's eyes.
XDo not immerse spotlight in water.
Additional safety instructions for batteries and chargers
Batteries
XNever attempt to open for any reason.
XDo not charge damaged batteries.
XDo not expose the battery to water.
XDo not expose the battery to heat.
XDo not store in locations where the temperature may
exceed 40°C.
XCharge only at ambient temperatures between 4°C and
40°C.
XCharge only using the chargers provided with the tool.
XWhen disposing of batteries, follow the instructions
given in the section "Protecting the environment".
Warning! To reduce the risk of injury, the user must
read the instruction manual.
Warning! Do not touch the lens as it becomes very
hot during operation and remains hot for several
minutes after the spotlight is switched off.
Warning! Burn hazard. Hot lens may cause
property damage or fire. Do not touch or obstruct
the lens.

4
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your Black & Decker charger only to charge the battery
in the tool with which it was supplied. Other batteries could
burst, causing personal injury and damage.
XNever attempt to charge non-rechargeable batteries.
XHave defective cords replaced immediately.
XDo not expose the charger to water.
XDo not open the charger.
XDo not probe the charger.
The spotlight must be placed in a well ventilated area when
charging.
All batteries lose charge with time, specially when they are
warm. Recharge the unit every two months for 24 hours
when not in frequent use.
If the unit is not going to be used for extended periods,
disconnect the charger and store in a cool, dry place.
The following symbols are found on your charger:
Features
This appliance includes some or all of the following features:
1. Carry handle
2. 2 Position brightness switch (high and low setting)
3. Charging LED indicator
4. Carry lanyard
5. Trigger lock
6. Pistol grip
7. On/off trigger switch
8. Charging socket
9. Quartz halogen bulb
10. Charger jack plug
11. Mains charger adaptor
Charging the spotlight (fig. A & B)
This spotlight is shipped in a partially charged state.
XCharge the spotlight before first use using the mains
charging adaptor (11) for 24 hours or until the green
charging LED (3) lights.
XCharge after each use until the green charging LED
indicator (3) lights.
The LED (3) indicates the battery level whilst charging.
XOne red LED indicates that the unit requires charging.
XTwo red LEDs indicate a high level of charge remaining.
XThe green LED lights shows the unit is fully charged.
Charging with the mains charger (fig. B)
XMake sure that the spotlight is off (the trigger lock (5) is
in the off position and the trigger (7) is not pressed).
Note: To ensure optimum battery life do not charge for
longer than 48 hours.
XInsert the charger jack plug (10) into the charging
socket (8).
XInsert the mains charging adaptor (11) into a mains
power socket.
XCharge until the green charging status LED (3) lights
(approximately 24 hours).
Use
XBefore operating the spotlight remove the charger jack
plug (10) from the charging socket (8).
Operating the spotlight (fig. C)
XMove the trigger lock (5) to the unlocked position.
XTo lock the trigger switch (7) in the on position, press the
trigger switch (7) and push in the trigger lock (5).
XTo shut the spotlight off, press the trigger (7) and move
the trigger lock (5) to the unlocked position.
XRelease the trigger (7).
Your charger is double insulated; therefore no earth
wire is required.
Read all of this instruction manual carefully.
This appliance is intended for indoor use only
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charging base
must be disconnected from the mains supply and
taken to an authorised service centre for repair.
This product must not be disposed of with normal
household waste.
130oC

5
High and low brightness switch (fig. D)
To extend the run time of the spotlight the unit is fitted with a
brightness switch (2).
XSlide the switch (2) forward towards the bulb to set the
spotlight on high beam.
XSlide the switch (2) to the rear to set the spotlight on low
beam (extended run time).
Using the built-in carry lanyard
XThe carry lanyard (4) may be used to store or carry the
spotlight. Adjust the slide on the cords to keep the
lanyard secure around the supporting object.
Maintenance
Your Black & Decker tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Warning! Before performing any maintenance or cleaning
on the appliance, unplug the appliance.
XFrom time to time wipe the appliance with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do
not immerse the appliance in water.
Protecting the environment
Should you find one day that your appliance needs
replacement, or if it is of no further use to you, think of the
protection of the environment. Black & Decker repair agents
will accept old Black & Decker tools and ensure that they are
disposed of in an environmentally safe way.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have
reached the end of their working life. To take advantage of
this service please return your product to any authorised
repair agent who will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local Black & Decker office at the
address indicated in this manual. Alternatively, a list of
authorised Black & Decker repair agents and full details of
our after-sales service and contacts are available on the
Internet at: www.2helpU.com.
XDo not short-circuit the battery terminals.
XDo not dispose of the battery in fire, as this may result in
an explosion.
XBe aware that the battery is heavy.
XRun the battery down completely, then remove it from
the appliance.
XNiCd, NiMh, Lithium Ion and Lead Acid (Pb) batteries
are recyclable. They must not be disposed of with
household waste. Place the battery in suitable
packaging to ensure that the terminals cannot be short-
circuited. Take the battery to any authorised repair
agent or a local recycling station
Separate collection. This product must not be
disposed of with normal household waste.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials
Black & Decker batteries can be recharged many
times. At the end of their useful life, discard
batteries with due care for our environment:

6
Technical data
EC declaration of conformity
BDSL301 TYPE 1, BDSL302 TYPE 1
Black & Decker declares that these products conform to:
Standards & Legislation.
EN60598, 2006/95/EEC
The undersigned is responsible for compilation of the
technical file and makes this declaration on behalf of
Black & Decker
Kevin Hewitt
Director of Consumer Engineering
Spennymoor, County Durham, DL16 6JG,
United Kingdom
08-08-2008
Guarantee
Black & Decker is confident of the quality of its products and
offers an outstanding guarantee. This guarantee statement
is in addition to and in no way prejudices your statutory
rights. The guarantee is valid within the territories of the
Member States of the European Union and the European
Free Trade Area.
If a Black & Decker product becomes defective due to faulty
materials, workmanship or lack of conformity, within 24
months from the date of purchase, Black & Decker
guarantees to replace defective parts, repair products
subjected to fair wear and tear or replace such products to
make sure of the minimum inconvenience to the customer
unless:
XThe product has been used for trade, professional or
hire purposes.
XThe product has been subjected to misuse or neglect.
XThe product has sustained damage through foreign
objects, substances or accidents.
XRepairs have been attempted by persons other than
authorised repair agents or Black & Decker service
staff.
To claim on the guarantee, you will need to submit proof of
purchase to the seller or an authorised repair agent. You can
check the location of your nearest authorised repair agent by
contacting your local Black & Decker office at the address
indicated in this manual. Alternatively, a list of authorised
Black & Decker repair agents and full details of our after-
sales service and contacts are available on the Internet at:
www.2helpU.com
Please visit our website www.blackanddecker.co.uk to
register your new Black & Decker product and to be kept up
to date on new products and special offers. Further
information on the Black & Decker brand and our range of
products is available at www.blackanddecker.co.uk.
BDSL301 BDSL302
Input voltage Vdc 12 12
Input current
(max)
mA 300 300
Unit weight kg 1.0 1.5
Runtime high min 17 18
Runtime low min 24 25
Battery Type 6 V 3 Ah SLA 12 V 3 Ah SLA
Bulb Type 6 V H3 35/25 W
halogen
12 V H3 55/35 W
halogen
Light Intensity lm 300 760
Charger
Input Vac 230 230
Approx.
charging time
h 18 - 24 18 - 24
Weight kg 0.2 0.2

TYP.
www.2helpU.com 29 - 08 - 08
E15469
BDSL301 - BDSL302 1
Partial support - Only parts shown available Nur die aufgefuerten teile sind lieferbar Reparation partielle - Seules les pieces indiquees sont disponibles Supporto parziale - Sono disponibili soltanto le parti evidenziate Solo estan disponibles las peizas listadas So se encontram disponiveis as pecas listadas Gedeeltelijke ondersteuning - alleen de getoonde onderdelen zijn beschikbaar
BDSL301 BDSL302
11

$XVWUDOLD
%ODFN'HFNHU$XVWUDOLD3W\/WG 7HO
)OHWFKHU5RDG0RRURROEDUN )D[
9LFWRULD

1HZ=HDODQG
%ODFN'HFNHU 7HO
7H$SXQJD3ODFH )D[
0W:HOOLQJWRQ
$XFNODQG
8QLWHG.LQJGRP
%ODFN'HFNHU 7HO
%DWK5RDG )D[
6ORXJK%HUNVKLUH6/<' +HOSOLQH
90541396 L-08/08