BlackVue 750G PRO Reference guide

Checking WiFi details:
1. Power off the dashcam and remove the cables.
2. Remove the camera.
3. Remove the microSD card (press down on card gently to release it).
2. Insert the microSD card into the microSD card reader.
3. Connect the microSD card reader to your computer.
4. Download and install the BlackVue Windows PC Viewer.
5. Run the program after installation and click SD Card Viewer.

6. Click the Setting cog wheel.
7. Click on Firmware tab at the top of the settings page.
8. Click the WiFi tab then check what the SSID and password are.
9. At the bottom of the page, click Reset then Save and close. You can also manually type in a new SSID and
password if you wish.
NOTE: The SSID and Password fields will clear and show as empty. This is normal so you can proceed to point 10.
10. Remove the SD card and place it back into the camera and turn the camera back on.
11. You should be able to connect to the wifi now using the credentials shown on the camera.
If you still can’t connect, then go back to step 9 and enter the details manually exactly as they are shown (including
upper and lower case) on the camera for the SSID and Password then Save and Close.