Blagdon Amphibious IQ Series User manual

FILTER
POND
FILTER
POND

Warning - ensure the pump is turned off at the mains power supply before any
maintenance is undertaken

Message
displayed on
digital display
Issue Action required Reset power
Jammed, Clean
Impeller,
Clean Rotor.
An object has
caused an
obstruction of
the impeller –
stopping it from
being able to spin.
Turn off the pump
at the socket , open
the cage, clean the
impeller and impeller
chamber – ensur-
ing to remove any
obstructions
If the pump has remained
blocked for a period of
time the display will read:
jammed clean pump clean
rotor reset power. After
cleaning turn the power
off at the mains supply for
a minimum of 5 seconds
to enable the pump to run
again
Low Water, Add
Water
The water level
in the pond has
dropped.
Add dechlorinated
water to raise the
water level back to
original depth.
If the pump has been
without water for a period
of time, the display will read:
low water add water reset
power. After adding water,
or solving any leaking issues,
turn the pump off at the
mains power supply for a
minimum of 5 seconds to
enable the pump to run
again.
Check pump
cable and
connector
Either:
-The plug from
the pump to the
controller has not
been connected
correctly.
-Or, there may
be damage to the
pump cable.
- Ensure the plug is
fully inserted into
the socket on the
controller.
- Check cable for any
damage, if damage is
found, cease using the
pump.
After ensuring the
connector is correctly
inserted, turn the power
off at the mains supply for
a minimum of 5 seconds
to enable the pump to run
again.