Enabling Devices Tickle Tube User manual

For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
1-800-832-8697
[email protected]
Tickle Tube #7909
USER’S GUIDE
50 Broadway
Hawthorne, NY 10532
Tel. [phone] / Fax [phone]
Toll Free 800.832.8697
www.enablingdevices.com

Explore!
Experience the many tactile sensations of our fun Tickle Tube – bead chains,
a mirror, gooshy pad, multi-colored blinking lights, music and vibration.
Outside blinking lights encourage exploration. Music and vibration is
adjustable. Lights and vibration can also be turned off. Size: 12"L x 8"W x 6
¾"H. Requires 4 C Batteries. Weight: 3¼ lbs.
Operation:
1. The Tickle Tube requires 4 C batteries to operate. Use alkaline batteries
only (e.g. Duracell or Energizer brand). Do not use rechargeable batteries
or any other type of batteries because they supply lower voltage and the
unit will not perform properly. Never mix old and new batteries together
or different brands or types together.
2. Carefully turn over unit to reveal battery compartments. Remove the
Phillips Head screws from the battery compartment covers. Next slide
the battery compartment covers off and insert the “C” batteries into the
holder. Replace the covers and screws.
3. There are 3 controls on the back of the unit. One is your adjustable
On/Off/Volume knob. This controls the volume of the music and turns
the Tickle Tube ON/Off. The second it the On/Off toggle switch to control
the six flashing locator lights. When set to On the six locator light will
flash, encouraging exploration. The third is the Vibration adjustment
knob. Please Note: when using the Vibration knob, the adjustment of the
Vibrations does not take effect until the knob is turned approximately
50% of the way.
4. Set the ON/OFF/VOLUME switch to the desired VOLUME level. As you
press your hand on the gooshy pad you will feel vibration, see multi-
colored blinking lights and hear music. The music, lights and vibration
will play for approximately 5 seconds each time the gooshy pad is
pressed. Please Note: When the gooshy pad is pressed, if you have the
locator lights set to, on they will turn off during activation. Once the
lights, music and vibration stop they will turn back on.
Troubleshooting:
Problem: The Tickle Tube does not work.
Action #1: Check the batteries for proper installation, as noted in operation
No. 2.
Action #2: Check batteries for freshness, if weak or dead replace with new
batteries.
Action #3: Make sure there is nothing obstructing the beads from moving.
Care of Unit:
The Tickle Tube can be wiped clean with any household multi-purpose
cleaner and disinfectant. We recommend Simple Green, which is a non toxic
biodegradable all-purpose cleaner. The ball can be removed for cleaning.
Do not submerge the unit, as it will damage the contents and the electrical
components.
Do not use abrasive cleaners, as they will scratch the surface of the unit.
Rev 10/10/17