BLOTZ B28-ME-008 User manual

28mm Middle Eastern Building #8
B28-ME-008
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the three walls shown above from the
sprue.
Glue them together as shown to form a zig-zag shape.
Attach them to the base.
Take the two remaining tall walls.
Glue them into position.
Then take the two remaining shorter walls.
Glue these into place.
Take the roof supports as shown above.

Glue them into place so that they extend through
the wall in the same way as the ones in the
building shown above. The strip with short lugs
goes into the lower set of holes in the centre wall.
Glue the door into position.
Place (do not glue) the roof into position, then glue
the trapdoor to it.
The completed building.