BodyMed ZZHP147 User manual

Instruction Manual
For models ZZHP147, ZZHP1414,
ZZHP1427, ZZHP1427BLK
and ZZHP832U
Digital Moist Heating Pad
FAILURE TO FOLLOW THE INSTRUCTION WILL VOID ALL WARRANTY REPLACEMENT
OR CREDIT

Table of Contents

Introduction To Moist Heat Therapy
The application of moist heat is a commonly prescribed therapy in medical practice
today. Controlled moist heat is especially useful for temporary pain relief associated with
muscle strains and spasms, joint pain and inammation.
The LCD display performs multiple functions, not only to set up temperature and time,
but also has a locking function to avoid any incidental touching.
A warning signal will light up on the screen when the product is active.
The heating pad is intended for physical therapy. For normal treatment, 15 minutes on
a cycle is sufcient. Do not exceed a total treatment duration of more than 30 minutes,
twice a day.
Always consult your physician for appropriate course of treatment.
The manufacturer and its distributor assume no liability for harm caused by misuse of the
device.

Device Description
The BodyMed® Digital Moist heating Pad includes high-grade intensive ceramics. The
digital far infrared ray moisture heating pad adopts the latest high-density electric carbon
wire to increase temperature quickly.
NOTE: During the rst 10 minutes of initial operation, the heating pad will go through a
“System Check” for temperature settings. Inconsistent temperature readings between
the “Setup” and the “Real-Time” temperature screens
may appear. This is normal and the temperature reading will level off once the “System
Check” is complete. The “Real-Time” temperature is NOT accurate during the “System
Check.” During the heat up phase, the initial temperature will exceed the set temperature
and then decrease down the set temperature. All the temperature change readings will
be displayed on the screen.

LCD

Button Function

Instructions For Use
5. When you are ready to begin, position the Digital Moist Heating Pad over the
area you wish to treat. Direct contact with bare skin produces the most
benet. DO NOT LIE or SIT on the Digital Moist Heating Pad.
4. Plug into outlet (110V). A “beep” sound indicates it is running normally.

Instructions For Use
10. After selecting the time, by pressing the button, the selected time will
display on the time indicator. The time will increase or decrease when
either the button is pressed. Pressing either the button, the
time will increase or decrease for every one minute. Press and hold either
the button to increase or decrease the time every ve minutes,
time level ranges from 0-60 minutes. When time is up, the power will shut
off automatically.
12. The latest setting time and temperature will be memorized automatically
when you shut the product off (to return to initial settings, unplug the unit).

Safety Notes
• Use of this heating pad is not intended as a substitute for consultation with
your physician.
• Do not use gasoline, paint thinner, or other strong solvents in proximity to
this product.
• Handle with care.
• Please consult your physician before using this product.
• Do not submerge in water.

WARNINGS
• Do not use on areas with sensitive skin.
• Do not crush display board.
• Carefully examine inner cover before each use. Discard the pad if inner
covering shows any signs of deterioration.
• Do not use pins or other metallic means to fasten this pad in place.
• Consult with your physician before using this device.
• For human use ONLY.
FAILURE TO FOLLOW THE ABOVE WARNINGS WILL VOID ALL WARRANTY REPLACEMENT
OR CREDIT

Output: Moisture heating.
Cover: 60% cotton, 40% polyester - washable.
Display: Numerical LCD (liquid crystal display).
Button: Rubber made in double colors.
Sensor: High resolution Digital thermal sensor.
Control: Pulse trigger-control solid switched.
Circuit: Digital Processor.
Protection: Thermal switched.
Mode of Operation: Continuous operation.
Heating: Select 86-166oF (oF/unit) temperature output.
Timer: 1 - 60 minute (1 minute/unit). Auto shut off.
Power Consumption: AC 90 - 125V ~ 40 - 60Hz
ZZHP1427 2.2A/290W
ZZHP1427BLK 2.2A/290W
ZZHP1414 1.1A/145W
ZZHP147 0.6A/80W
ZZHP832U 2A/260W
Product Specications

Pad Size (W x L): ZZHP1427:
ZZHP1427BLK:
ZZHP1414:
ZZHP147:
ZZHP832U:
14" x 27"
14" x 27"
14" x 14"
14" x 7"
8" x 32"
Operating Condition: Temperature:
Humidity:
68 - 104oF
30 - 75% RH
Storage Condition: Temperature:
Humidity:
50 - 122oF
10 - 90% RH
Transportation Condition: Temperature:
Humidity:
14 - 158oF
10 - 90% RH
Classication
** Do not expose the Heating Pad to temperature extremes (below 50F or over 122F)
nor excessive humidity (>90% RH).
*** Equipment is not suitable for use in the presence of a flammable anesthetic mixture
with air oxygen, or nitrous oxide.

T
U
V
R
h
e
i
n
l
a
n
d
o
f
N
o
r
t
h
A
m
e
r
i
c
a
.
I
n
c
.
CU
S
Note
The heating pad is intended for physical therapy, not for keeping warm.
CHECKING THE CONTENTS
Make sure the eece cover is included in the package. If it is missing or damaged, please
contact your local dealer.

Specications

Specications

Specications

Specications

Maintenance
• Do not clean the heating pad unit.

Limited Product Warranty
BODYMED® MAKES NO OTHER WARRANTY, EXPRESS OR IMPLIED, INCLUDING, WITHOUT
LIMITATION ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE, ALL SUCH WARRANTIES BEING HEREBY EXPRESSLY EXCLUDED.
BODYMED® SHALL NOT BE LIABLE FOR ANY INDIRECT, INCIDENTAL,
CONDQUENTIAL OR SPECIAL DAMAGES, WHETHER ARISING UNDER CONTRACT,
TORT, STRICT LIABILITY, STATUTE OR OTHER FORM OF ACTION OR ANY DAMAGES IN
EXCESS OF THE COST OF THE REPLACEMENT OF THE PRODUCT.